Boot Scoot Bike User Manual

Thank you for purchasing a Boot Scoot. We know your child will enjoy their Boot Scoot if they learn to use it
safely. Safety should be your chief concern. Please use common sense and caution when using this moving
toy. Do not allow your child to use this toy until you have thoroughly read and understand this User's Manual.
Safety: Children should always wear helmets and shoes when using this toy. Children should always use this
toy under an adult's supervision. Since Boot Scoot Bikes have no pedals, children use their feet to brake and
stop. Please ensure your child understands how to slow down and stop before riding.
Ensure that all hardware is secure and tight before each use.
Ensure that the area where your child will be riding is safe and free of obstructions. Boot Scoot Bikes are
intended for flat, level surfaces free of debris, ice, sand, gravel, and water.
If the bike or any of its parts becomes damaged, discontinue use until the damaged part(s) are replaced or
properly repaired. Use only Boot Scoot Bike replacement parts.
This is a child's toy. Maximum suggested weight: 80 lbs.
Liability: Boot Scoot Bikes Series of ESL Squared LLC is not responsible for unsafe operation of this ride-on
toy, injuries incurred while using this ride-on toy, or any non-compliance of this User's Manual. As with any
physical exercise, bike riding can be a hazardous activity. Use at your own risk.
Boot Scoot Bike Parts List:
Main Frame with Rear Fork
Front Fork and Assembly
Ball Bearing Rings (2)
Chrome Collar
Chrome Locking Nut
Chrome Spacer Ring
Adjustable Seat Assembly
Saddle
Assembly Instructions:
Suggested assembly tools (not supplied): 15mm socket or open-ended wrench, or adjustable wrench.
PLEASE NOTE: Some of these steps may have been completed in the factory. However, please go through all
steps and check pre-assembled parts to ensure precise assembly.
1. Open carton. Remove all contents and packaging from box. Ensure all parts are included using the
above parts list. If any parts are missing, STOP. Contact Boot Scoot Bikes at
bootscootbikes@gmail.com for replacement parts or call 630-945-4875.
2. Place bike frame upright on a flat, level surface.
3. Insert saddle assembly into seat post at desired height. You may want to add a little grease to the
saddle post to make adjusting the seat height easier in the future. Tighten seat at desired height with
the Allen wrench provided. See photo 11 below.
4. Determine the center of your handlebars. Remember, they should be facing up like a "Y" when fully
USER'S MANUAL
Wheels (pre-assembled)
Outer Cap Nut (4)
Inner Nut (4)
Axle (2)
Handlebar with Grips
Adjustable Lock Kit (pre-assembled)
Allen wrench and mini-wrench for assembly