Installing The Tv To The Wall - Sony Bravia KDL-65W950B Reference Manual

Installing the TV to the Wall

This TV's instruction manual only shows the steps on preparing the installation of the TV before
installing to the wall.
To Customers:
For product protection and safety reasons, Sony strongly recommends that installation of your TV be
performed by Sony dealers or licensed contractors. Do not attempt to install it yourself.
To Sony Dealers and Contractors:
Provide full attention to safety during the installation, periodic maintenance and examination of this
product.
Sufficient expertise is required for installing this product, especially to determine the strength of the wall for
withstanding the TV's weight. Be sure to entrust the attachment of this product to the wall to Sony dealers
or licensed contractors and pay adequate attention to safety during the installation. Sony is not liable for
any damage or injury caused by mishandling or improper installation.
Use the Wall-Mount Bracket SU-WL450 (not supplied) to install the TV to the wall.
When installing the Wall-Mount Bracket, also refer to the Operating Instructions and Installation Guide
supplied with the Wall-Mount Bracket.
Note
• Be sure to store the removed screws in a safe place, keeping them away from children.
1
Remove the screws from the rear of the TV.
* Do not remove for Super Slim mounting
2
Attach Wall-Mount Attachment J (supplied with the TV) to the rear of the TV (to make it
parallel with the wall). You do not need to perform this step for Super Slim mounting.
1
2
Note
• If using an electric screwdriver, set the torque at approximately 1.5 N·m {15 kgf·cm}.
8
GB
1
2
Wall-Mount Attachment (J2)
(supplied with the TV)
Wall-Mount Attachment (J1)
(supplied with the TV)
*