Table of Contents
Advertisement
2. Act as Slave test station:
You can press [Start] button to start the slave test station. The "Slave Test Station"
window will be displayed after pressing [Start] button.
The "Slave Test Station" window contains following status/statistical information during
the Link Quality Test session:
Fig. Act as Slave test station
¨
My Address:
¨
Packet Received:
¨
Elapsed Time:
¨
Signal Level:
calculated as the percentage of its signal level measurement relative to the full signal
level.
3. Loop-back through Access Point:
The slave test station's physical address.
Total test packets received.
Total testing time.
The signal level when receiving last test packet. The signal level is
-41-
Advertisement
Table of Contents
