Do you have a question about the B33Z08 and is the answer not in the manual?
Questions and answers
Kevin Virtue
February 4, 2025
Hi- I have the 33cc Ice Auger. It ran great. Then when squeezing accelerator it bogged down and stalled. I changed gas, and did same. When I put choke partially on, it will run better, but then stalls out. Any help? Thanks
1 comments:
Kevin Virtue
February 4, 2025
@Kevin Virtue I've only used ice auger for about 1 hour total since I bought it a few years ago
Summary of Contents for Polar Fire B33Z08
Page 1
ASSEMBLY INSTRUCTIONS PARTS DIAGRAMS Ice Auger B33Z08/MODEL PFPX-338...
Page 2
CONGRATULATIONS… on purchasing your new Power Ice Auger.We know that you are anxious to get right to work,but before you do ,it is important that you take a few moments and familiarize yourself with your new Ice Auger and its operating instructions.We have worked to ensure that the ice auger meets high standards for usability and durability.With proper care,your ice auger will provide many years of service.Please take the time to register your new purchase as well as read this manual care- fully to learn how to correctly operate and maintain your equipment.
SAFETY WARNING OWNER’S RESPONSIBILITY It is the owner’s responsibility for accurate assembly and WARNING SIGNIFIES A DANGER WHERE safe, effective use of the auger. YOU COULD BE SEROIUSLY INJURIED • Read and follow all safety instructions. OR HAVE AN ACCIDENT THAT COULD Carefully follow all assembly instructions.
CAUTION CAUTION HOT GASES ARE A NORMAL BY-PRODUCT OF A TAKE GREAT CAUTION WITH MUFFLER, MUFFLER FUNCTIONING CATALYTIC CONVERTER. FOLLOW GUARD & OTHER PARTS OF ENGINE AS THEY ALL SAFETY INSTRUCTIONS TO PREVENT BURNS BECOME EXTREMELY HOT DURING OPERATION. AND FIRES THESE PARTS REMAIN EXTREMELY HOT EVEN AFTER ENGINE HAS STOPPED.
OPERATION CAUTION STEPS FOR WORKING ON ENGINE OR AUGER Turn off engine switch. NEVER ALTER/MODIFY ENGINE OR AUGER IN NO WAY ALTER OR MODIFY THE ENGINE FROM HOW Disconnect the spark plug wire from the spark plug. IT CAME FROM THE FACTORY. SERIOUS INJURY OR Securely place the disconnected spark plug wire away from the DEATH MAY OCCUR IF IT IS ALTERED IN ANY WAY.
CAUTION Filling Gas Tank ● Shut-off engine and allow engine to completely cool before refill- ing the gas tank. ALWAYS HANDLE FUEL IN A WELL VENTILATED Move to a well ventilated area, outdoors, away from flames and ● AREA, OUTDOORS, AWAY FROM FLAMES OR sparks.
Page 7
WARNING CAUTION MAKE SURE THE UNIT IS IN A STABLE POSITION ALWAYS HANDLE FUEL IN A WELL VENTILATED AREA, BEFORE PULLING STARTER. OUT DOORS, AWAY FROM FLAMES OR SPARKS. ALWAYS WEAR A PROTECTIVE HEARING DEVICE. WHEN THE UNIT STARTS TO FIRE OR RUN, RELEASE DO NOT START ENGINE IF FUEL IS SPILLED.
HOT ENGINE START: CAUTION 1. Continue with Step 6 of Cold Engine Starting. If engine does not fire, refer to Step 1 of Warm Engine Starting. TO PREVENT ACCIDENTAL STARTING: AVOID INJURY! ENGINE MUST BE TURNED OFF DO NOT ATTEMPT TO START ENGINE IN THE FOLLOWING WAYS: AND COOL, AND SPARK PLUG WIRE MUST BE RE- MOVED FROM SPARK PLUG BEFORE CHECKING •...
Page 9
STEPS FOR CLEANING BLOCK STYLE FOAM AIR FILTER NOTE: SEE PARTS EXPLOSION ON PAGE 16 Before removing the air filter cover, move the choke lever to the choke position. (Figure 1) To remove air filter cover, loosen and remove the bolt on the cover and squeeze the latch tabs on both sides of the cover.
Page 10
LONG TERM STORAGE CAUTION • If your ice auger will not be ran for more than one month, pre- pare it for long term storage. AVOID INJURY! TO AVOID INJURY OR DEATH, NEV- Steps for Long Term Storage ER SIPHON FUEL BY MOUTH. 1.
CAUTION IMPORTANT PRACTICE SAFETY AT ALL TIMES. BEFORE WHEN CALLING SERVICE, WITH ATTEMPTING MAINTENANCE QUESTIONS REGARDING YOUR AUGER OR REPAIR, SPARK PLUG WIRE MUST BE FOR PARTS, PLEASE HAVE THE FOLLOWING INFORMATION AVAILABLE WITH YOUR DISCONNECTED AND ENGINE MUST BE REQUEST: TURNED OFF AND ALLOWED TO COOL.
Page 12
POSSIBLE CAUSE REMEDY/ACTION PROBLEM Power switch off Flip switch to ON position Spark plug wire disconnected Connect spark plug wire to spark plug Out of fuel Refuel Spark plug wet, faulty or improperly Engine will not start Clean, replace or gap spark plug gapped Squeeze throttle control when Throttle control not held open...
Page 14
PART DESCRIPTION QTY. PART NO. DESCRIPTION QTY. B330001 FLYWHEEL, MAGNETO GAS TANK B330037 B330002 NUT, FLANGE M8 B330038 GAS CAP, MANUAL VENTING B330003 WASHER, ROTOR GASKET B330039 B330004 CLUTCH ROTOR ASSEMBLY ENGINE WIRE B330040 SPRING, CLUTCH GROMMET, 2-HOLE GAS TANK B330041 B330005 WASHER, SPRING...
Page 16
B33 POWER HEAD & AUGER PARTS LIST PART PART DESCRIPTION DESCRIPTION QTY. QTY. BOLT 3/8-16 X 1-1/4 SHCS GAS ENGINE, 33CC B33.02A HANDLEBAR BD08 ICE BLADES 8” COMPLETE SET OF 2 BLADES B33.03 TRANSMISSION COMPLETE BD09 ICE BLADES 9” TRIGGER ASSEMBLY, LONG Y43.03 COMPLETE SET, SET OF 2 THROW...
Need help?
Do you have a question about the B33Z08 and is the answer not in the manual?
Questions and answers
Hi- I have the 33cc Ice Auger. It ran great. Then when squeezing accelerator it bogged down and stalled. I changed gas, and did same. When I put choke partially on, it will run better, but then stalls out. Any help? Thanks
@Kevin Virtue I've only used ice auger for about 1 hour total since I bought it a few years ago