Electric Fuses - Skoda Superb 2010 Supplement To The Owner's Manual

Hide thumbs Also See for Superb 2010:
Table of Contents

Advertisement

8
Tow-starting and towing vehicle
– Drive the vehicle approx. 10 metres forwards or backwards to allow the sealing
agent to distribute in the tyre.
– Screw the tyre inflation hose of the air compressor
valve and repeat the inflation procedure.
– If you cannot reach the required tyre inflation pressure here either, this means the
tyre has sustained too much damage. You cannot seal with tyre with the break-
down kit 
.
– Switch off the air compressor with the ON and OFF switch.
A
– Remove the tyre inflation hose
5
After reaching a tyre inflation pressure of 2.0 – 2.5 bar, resume driving at a maximum
speed of 80 km/h (50 mph).
Check the tyre inflation pressure after driving 10 minutes  page 8, "Check after
driving for 10 minutes".
WARNING
During inflation, the tyre inflation hose and air compressor may get hot-
risk of injury!
Do not place hot tyre inflation hoses or hot air compressors on flammable
materials - risk of fire!
If you cannot inflate the tyre to at least 2.0 bar, this means the damage
sustained was too serious. The sealing agent cannot be used to seal the tyre. Do
not drive the vehicle. Get professional assistance.
Caution
Switch off the air compressor after running 8 minutes at the latest - danger of over-
heating! Allow the air compressor to cool a few moments before switching it on
again.
Check after driving for 10 minutes
Check the tyre inflation pressure after driving 10 minutes.
A
firmly back onto the tyre
5
from the tyre valve.
If the tyre inflation pressure is 1.3 bar or less:
– Do not drive the vehicle! You cannot properly seal with tyre with the breakdown
kit.
– Obtain professional assistance.
If the tyre inflation pressure is 1.3 bar or more:
– Adjust the tyre inflation pressure to the correct value (see inside of fuel filler cap).
– Continue driving carefully to the nearest specialist garage at a maximum speed of
80 km/h (50 mph).
Tow-starting and towing vehicle
General
Caution
Do not push or two the vehicle to start the engine - likely engine damage! In vehicles
with catalytic converters, fuel may get into the catalytic converter where it may ignite.
This results in the catalytic converter overheating and being destroyed. To help start
the engine, you can use a battery from another vehicle, see Owner's manual.

Electric fuses

Fuse assignment in engine compartment - version 1
No.
Power consumer
F28
Engine control unit
F30
Control unit for auxiliary heating
Amperes
15
30

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents