WIRING DIAGRAM
1. Rewire motor per data plate on motor or instruction sheet.
2. Check pressure switch electric rating and replace if
necessary.
3. Check electric rating of thermal over load switch or
magnetic starter and replace complete switch or thermal
overload elements as required.
Pressure
switch
MOTOR
LINE
L1
T1
INCOMING POWER
L2
L3
T2
T3
Incoming Power to be wired to Mag Starter only!
L1, L2, L3 indicates supply line terminals.
T1, T2, T3 indicates load terminals.
single Phase
three Phase
Pressure switch
MOTOR
7