PARTS DIAGRAM
OPERATING INSTRUCTIONS
Remove the Russell Hobbs Foot Massager from the packaging.
Remember to set a towel nearby to dry feet afterwards.
1. Make sure the dial is on the "0" or OFF position.
2. Fill the Foot Massager with the desired temperature warm water. The unit will maintain this
temperature for the duration of use.
Important:
Ensure the unit is unplugged before filling with water. Do not overfill the basin of the
foot spa over the 'MAX' level (see 'water level indicator' location on Parts Diagram).
3. Plug in the appliance at the mains socket.
4. Sit down in a comfortable chair and place your feet in the foot spa.
5. Select the vibrating massage function by using the dial on the control panel, as follows:
a. Position 0: Off
b. Position 1: Bubble + Massage + Infrared
This setting provides a comfortable vibration massage. The stimu-nodes act as fingers
that provide the soles of your feet with an effective massage while the air jets offers a
relaxing bubble bath. The infrared heat provides concentrated heat for tired and aching
feet.
c. Position 2: Water heat-function + Aeration
With this setting the water temperature will be maintained at a comfortable temperature.
By adding a few drops of aromatic oil on the cotton pad inside the aroma diffuser you
Pedicure Centre Cover/ Splash Guard
Pedicure attachments
Control Panel dial
Battery-operated pedicure tool
Aroma Diffuser/ Nail Polish Dryer
Infrared Heat
Air Nozzle
Acupressure massage surface
Water Level Indicator
Drain Spout
4