Page 1
Interactive Whiteboard Setup Guide for For Windows 98SE/Me/2000 and XP Use this guide to quickly setup and use your mimioBoard interactively with a projector.
Page 2
Check your contents Your mimioBoard contains the following components: mimio Studio CD mimioBoard USB Cable mimioMouse Insert x2 mimio Styli and Caps x2 Expo Markers mimio Eraser Eraser Holder x1 AAA Battery and (Not used in Interactive Mode) (Not used in Interactive Mode) x4 N‐Cell Batteries ...
Page 3
Install mimio Studio 1. Insert the mimio Studio CD into your CD ROM drive. The mimio Studio CD will auto launch. 2. Select the desired installation language from the available options. 3. Select mimio Studio from Install Software. An installation application will launch.
Page 4
Setup your mimioBoard 1. Plug the included USB cable into the socket on the side of the mimioBoard. 2. Plug the other end of the USB cable into your PC USB port. The mimioBoard should be automatically detected. Refer to your system documentation if you canʹt find the USB port, or if your mimioBoard is not automatically detected. ...
Page 5
Setup your pen 1. Remove the end of the 4. Put the colored cap back stylus by twisting and on by snapping it into pulling. place. 5. Insert the mimioMouse into the stylus. 2. Remove the colored cap by pressing on the colored nodes and pulling.
Page 6
1. Project your Desktop image onto your whiteboard. Make sure there is a 2-3” buffer between the projected image and: • The edges of the whiteboard • The mimio device 2. Press the Interactive button on your mimio device. 3. Follow the onscreen instructions.
Page 7
Using the Interactive Mode • Use the mimio Stylus with the mimioMouse insert as a Mouse to control your Desktop or interact with applications. • Use the mimio Tools to annotate over any application. 1. Double-Click the mimio Tools shortcut on the Desktop.
Need help?
Do you have a question about the MimioBoard and is the answer not in the manual?
Questions and answers