Advertisement
Advertisement
Table of Contents
Summary of Contents for Resun EB-7DM
- Page 1 7” USB Monitor EB-7DM Manual...
-
Page 2: Table Of Contents
CONTENTS Safety Instructions ..........................Product Features ............................ connections and Installation ......................Installation Monitor Driver ......................EB-7DM Display Setting ........................System Requirements ......................... Specifications ............................Accessories .............................. troubleshootiong ............................ -
Page 3: Safety Instructions
-Make sure to use USB Cable (DC 5v, 500mA) only. EB-7DM doesn’t require any additional power source 2.Do not place EB-7DM in a location exposed to moisture, dust, smoke, water, or in a car. Otherwise, this may result in electric shock or fire. -
Page 4: Connections And Installation
-Do not power off or disconnect the USB cable until installation is completely finished. This may damage systems or may cause system errors. -The EB-7DM screen resolution is fixed for the best picture quality with each model. 1. Double click the icon... - Page 5 2. If you see following message window, select “I agree” to accept the terms of use 3. When the installation is complete, the EB-7DM setting icon appears on your system tray and the connected USB monitor information will pop-up. 4. After finish installation of the EB-7DM driver, please follow below steps for %Ë...
- Page 6 User may check the Operating System version by Right-click ‘My Computer’ !’ ‘Properties’ !’ ‘System Properties’ 2. EB-7DM is a USB monitor to be recognized as a Generic USB device. Therefore system boot-up screen or DOS screen cannot be displayed properly.
-
Page 7: Specifications
Q: No image on screen, I cannot turn on the EB-7DM A: Is USB cable connected and did you install EB-7DM driver yet? Please run ‘EB-7DM Installation Software’ in the CD. For more detail about driver installation, please refer to III. - Page 8 PC. Please refer to Microsoft homepage for more detail. Q: I cannot see DOS opening screen with EB-7DM when my PC is booting up. A: EB-7DM is using USB device. Since DOS doesn’t recognize USB Device while booting –up, EB-7DM cannot get video signal from the system.
- Page 9 Q: When EB-7DM connected with PC first, after PC starts, EB-7DM is standby and no display? A: Plug-out and plug in again with the USB cable between PC and EB-7DM; or press “POWER” button on EB-7DM to off, and then power on.
Need help?
Do you have a question about the EB-7DM and is the answer not in the manual?
Questions and answers