Conair GMT265XC User Manual page 6

7. Hold the trimmer in the way as shown in
Fig.3 with the thumb pressing the top front
part of the trimmer head and snap it off.
ON/OFF SWITCH
To operate, simply slide switch toward blade,
to stop push slide away
from blade.
CARE OF YOUR
TRIMMER
REPLACEMENT
(REMOVAL) OF BLADE SET
To remove blade set from your trimmer, make
sure the trimmer is in the OFF position. Remove
the blade set by placing thumb against the
smaller cutter and pushing forward, releasing
the cutter assembly from the trimmer housing.
Replace with new cutting system and reverse
the removal procedure, only this time place your
thumb on the large cutter and snap into place.
Make sure the taper control is set to the longest
#1 position.
BATTERY REMOVAL
CONTAINS NICKEL-METAL HYDRIDE BATTERY.
MUST BE COLLECTED, RECYCLED OR
DISPOSED OF PROPERLY. DO NOT DISPOSE
OF IN THE MUNICIPAL WASTE.
1. Using a small Phillips head screwdriver,
remove the 3 screws at the back of the
trimmer.
2. Remove the bottom housing and push the
batteries out and disconnect the leadwire
connected with +/– pole. Bring the batteries
to the nearest collection center for proper
disposal. DO NOT throw the battery into the
normal municipal waste system.