Light Settings figure1
Battery Charging
Adjusting the light – Off (A) is all the
Always switch the NIGHTRAZOR
u
u
way back on the intensity knob. Super
off before charging.
Bright (E) is all the way forward. There
Fully charge the NIGHTRAZOR
u
are clicks in between for Low (B)
prior to using.
Medium (C) and High (D).
In Use – The NIGHTRAZOR will
u
S-O-S flash – Turn the intensity knob to
u
make 4 short flashes every 60 seconds
Low. Now turn the intensity knob to
while you are using it to notify you of
Medium and back to Low three times
a low charge.
quickly. The light will flash in the S-O-S
pattern. You may turn the intensity
At this point you still have at least 12
u
knob to the level of brightness you
minutes of charge left on the high
prefer and it will continue to flash. To
setting. To make the battery last longer
turn it off just turn the intensity knob
adjust the light to a lower setting.
back to the Off setting.
Strobe flash – Turn the intensity knob
figure1
u
to Super Bright. Then turn the intensity
knob to High and back to Super Bright
three times quickly. Once the strobe
begins you may turn the intensity knob
to the level of brightness you prefer
(the strobe works only on Medium,
High and Super Bright settings). To
turn it off just turn the intensity knob
all the way back to the Off setting.
The NIGHTRAZOR has LED lights
u
that indicate battery charge level.
These are visible just inside the rim
of the optical lens at about the 10:00
o'clock position when viewed from
the front of the light. (Don't shine the
light in your eyes, it is bright!)
Red flashing LED – Indicates the light
u
will not work. Turn the intensity knob
to the off position and place the
NIGHTRAZOR on the charger for
a full charge which will take under 4
hours.
Battery Life – The chart below shows the typical battery life for the NIGHTRAZOR
A
B
C
D
E
When on the charger the red LED will
u
show solid while the light is charging.
When the Green LED shows solid the
light is fully charged.
2
The NIGHTRAZOR has a separate
u
charging cradle. It can be connected
to the supplied 110 VAC wall adaptor
or to an available accessory 12 VDC
vehicle power outlet adapter.
The NIGHTRAZOR may stay on the
u
plugged-in charger whenever you are
not using it so it will be ready to use
at all times.
3
1
To Attach the Charging Cradle
Angle the NIGHTRAZOR forward
and place the tab from the charging
cradle over the rim of the light
1
Tilt the NIGHTRAZOR
back and gently snap into
place. The silver contacts
2
on the light will align with
the copper contacts on
the charging cradle.
To Remove the Charging Cradle
Place your thumb on the back part of the Charging Cradle and
gently but firmly tilt the NIGHTRAZOR forward with your
other hand.
Need help?
Do you have a question about the NIGHTRAZOR and is the answer not in the manual?
Questions and answers