Summary of Contents for Aqua Jet SA 3995
- Page 1 Aqua Jet SA 3995 IMPORTANT NOTICE: PLEASE READ THIS IN DETAIL Please read this manual in detail prior to assembly and first use of the Aqua Jet Beware of the warnings and follow the safety precautions mentioned...
- Page 3 Model No. SA 3995 1 motor unit 1 x motor unit 1 battery unit 1 x battery unit 1 buoyancy cone 1 x buoyancy cone 1 x control handle bracket 2 x handles 1 x battery charger & power cord...
- Page 4 • Should not be used with children under 8 years of age • Disconnect battery after every use to avoid injury or damage • Always keep the Aqua Jet from exposure to direct sunlight while not in use as heat may damage the battery and shorten its product life and performance...
-
Page 5: Motor Assembly
Motor Assembly • Attach the buoyancy cone to a fully charged battery (please refer to page 5 & 6 for how to charge battery) by aligning the cone key to the battery key as indicated in diagram 1 • Rotate the cone 90 degrees in a clockwise direction until it locks into place as indicated in diagram 2 •... - Page 6 6 propeller are clean and free from obstructions. Your Aqua Jet is now ready to use - simply put it into the water, squeeze the control trigger and away you go! For optimum performance, your body should be in a horizontal position as you glide through the water.
-
Page 7: Charging The Battery
Charging the Battery • The Aqua Jet is specially designed to enable the user to replace a used up battery on the Board easily. Users should replace and charge the battery according to the following procedures so as to provide the best care for the product: 1. - Page 8 5. Pull open the vented plug as indicated in diagram 11 6. Allow at least one minute for the gas to dissipate 7. Plug the custom-made charge plug into the battery (it will not fit in if inserted in the wrong direction). See diagram 12 8.
- Page 9 If the control trigger is pressed and the motor driver does not respond or function properly 1. Check whether the battery compartment is attached to the driver firmly and ensure that the battery is fully charged. Also check whether there are any obstacles around the spring mechanism of the motor unit bracket that may affect the operation of the spring control 2.
-
Page 10: Care Of The Battery
• Never charge the battery in a sealed container • Never short the circuit of the battery • If the Aqua Jet is not used for a long period, ensure that the battery pack is released from the Motor Driver and is charged fully every three months •...
Need help?
Do you have a question about the SA 3995 and is the answer not in the manual?
Questions and answers