Table Of Washing Procedures - Midea MF710W User Manual

Operate Washing Machine
- Drum Clean
This cycle is specially set in this machine to clean the drum and tube. It applys 90 C
high temperature sterilization to make the clothes washing more green. When this
procedure is performed, the clothes or other washing cannot be added. When proper
amount of chlorine bleaching agent is put in, the barrel cleaning effect will be better.
The customer can use this procedure regularly according to the need.
- Bubble Removal Function
Bubble Check Function: Redundant bubbles will occur when there is excessive detergent,
which will affect Wash and Rinse effects. The procedure will check automatically and one
bubble removal procedure will be added automatically to remove bubbles when excessive
bubbles are checked. It will also remind the user to use less detergent during the next
similar washes.

Table of Washing Procedures

Load(kg)
6.0 7.0
1.5 1.5 2.0
Cotton Intensive 6.0 7.0
6.0 7.0
0 0 0
6.0 7.0
3.0 3.5
1.5 1.5 2.0
6.0 7.0
Energy test program cotton : intensive 60 C,the washing time is 180 minutes.
Standard wool program: wool 40 C
● Means must
○ Means optional
Means not necessary
Notes: The parameters in this table are only for user's reference. It is difference from the normal time
when using depend on the temperature and the load .
Default Default Time
Temp.( C)
(Min)
1000
5.0/6.0/7.0kg 600
5.0/6.0/7.0kg
Cold 15 600 1000
40 120
600 1000
NA 15 600 1000
90 110 400 400 500
60 120 600 1000
40 90 700
500 600
80 400 500
40 400
40 110 600 1000
P.16
Maintenance
Before your maintenance starts, please do pull out the power plug or disconnect power
and close the tap.
- Solvents are forbidden to avoid that the washing machine is damaged, and toxic gases
are generated or exploded.
- Never use water to sprinkle and wash the washing machine.
- It is forbidden that the detergents containing PCMX are used to clean the washing machine.
Cleaning and Maintenance of Washing Machine Cabinet
Proper maintenance on the washing machine can extend its working life. The surface can
be cleaned with diluted non-abrasive neutral detergents when necessary. If there is any
water overflow, use the wet cloth to wipe it off immediately. No sharp items are allowed to
strike the cabinet.
Notes: formic acid and its diluted solvents or equivalent are forbidden.
Clean Internal Drum
The rusts left inside the drum by the metal articles shall be removed immediately with
chlorine-free detergents.
Never use steel wool.
1200
Dispose a Frozen Washing Machine
1200
When the temperature drops below zero and your washing machine gets frozen, you may:
1200 1.Disconnect the power supply for the washing machine.
2.Wash the tap with warm water to loosen inlet pipe.
1200
3.Take down inlet pipe and immerse it in warm water.
400
4.Pour warm water into washing drum and wait for 10 minutes.
1200
5.Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally.
800 Notes: when the washing machine is reused, make sure the ambient temperature is above 0 C
Anti-freeze
400
If your washing machine is located in the room where it can get frozen easily, please drain
1200
the remaining water inside drain pipe and inlet pipe thoroughly.
Remove the remaining water in inlet pipe:
1.Close the tap.
2.Screw off the inlet pipe from tap and put its end into the container.
3.Start up any procedure except single Wash or Drain
procedure. Water will be drained out of inlet pipe if any
for about 40 seconds.
4.Reconnect the inlet pipe to tap.
Remove the remaining water in drain pump
T o avoid burning, it shall be done after the hot water
inside the machine cools down.
P.17