Advertisement
Important Notes on Terminal Connections
It is important that before connecting your Act C60 loudspeakers you refer to the
following notes and diagram and not the standard markings on the Wilson Benesch
terminal as the Act C60 allows for many different connection options.
Two pairs of red and black link leads are supplied with the hardware pack to allow for
single wire or bi-wire setup. When connecting the Act C60 a choice must be made
whether to run the tweeter at normal output, -1dB output or –2dB output. To select the
tweeter output, connect ONLY ONE of the top three positive inputs on the top terminal
block as per the diagram below. The negative tweeter input must always be
connected regardless of the positive tweeter output chosen.
The red and black lines below represent the link wires connected for single wired
operation
Connect
ONLY ONE
positive
tweeter
input
Act C60 Terminal Connections
13
Tweeter Positive –2dB output
Tweeter Positive –1dB output
Tweeter Positive 0dB output
Tweeter & Sphere Negative
Mid Driver & Sphere Positive
Mid Driver Negative
Bass Driver Positive
Bass Driver Negative
Advertisement
