Related Manuals for RTMOTION MK3.x Series
Summary of Contents for RTMOTION MK3.x Series
- Page 2 Table of Contents...
- Page 7 Table of Contents...
- Page 11 → → → → → →...
- Page 15 • • • •...
- Page 20 Visit: rtmotion.com/knowledge...
- Page 21 1. Run the Program. 2. Make sure the controller is turned off. Connect the USB cable from the Controller to your computer. Hold down the SET and POWER buttons simultaneously on the controller for about 2 seconds. The screen will display: PC MODE. The program will now detect and connect to the Controller.
- Page 22 Updating The Receiver 1. Run the Program. 2. Make sure the receiver is not powered and that no motors are attached. Connect the USB cable from the Receiver to your computer. The Receiver should power up. The program will now detect and connect to the Receiver. You should see, “Connected to Device”...
- Page 23 Updating a Motor 1. Run the Program. Make sure the Receiver is not powered and that no motors are attached. Connect the USB cable from the Receiver to your computer. The Receiver should power up. The program will now detect and connect to the Receiver. You should see, “Connected to Device”...
- Page 24 I get an “This application has failed to start because...” error. You may need to install the Microsoft Visual C++ 2010 Redistributable Package. The installer should install this if it’s not installed but they can also be manually installed from the programs /runtimes/ folder or downloaded from the microsoft site.
- Page 25 I'm still having problems. Please contact us at support@rtmotion.zendesk.com To help us diagnose the problem please supply as much detailed information as you can.
- Page 27 →...
- Page 36 Table of Contents...
Need help?
Do you have a question about the MK3.x Series and is the answer not in the manual?
Questions and answers