Table of Contents
Advertisement
Insert the drain hose into a drain pipe with a minimum diameter o f 4 cm, o r let it run into the sink, making sure to
avoid bendin g or crimping. Use the special plastic support that comes with the appliance. The free end of the hose
must be at a height between 40 and 100 cm and must not be immersed in water.
DISHWASHER
Inlet pipe connector Drain pipe connector
FRONT VIEW
Improper connection of the equipment earthing conductor can result in the risk of an
for personal safety:
electric shock.
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
Check with a qualified electrician or service representative if you are in doubt whether the
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
appliance is properly earthed.
CONNECTION
FROM THE POWER CORD.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a proper outlet.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time , let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water in let to be blocked and damage the a ppliance.
Please close the hydrant after using.
SINK
P O W E R O U T L E T
Min 100mm
14
EARTHING
Hide quick links:
Advertisement
Table of Contents
