Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for amerivap Steamax
-
Page 1: Operating Instructions
Steamax OPERATING INSTRUCTIONS Steam Vapor Cleaning System For Safely Cleaning and Sanitizing . . . Without Chemicals AmeriVap Systems, Inc. | 31 Successful Way, Dawsonville, GA 30534 ® Ph: 404.350.0239 | F a x: 404.350.9214 | Email: info@amerivap.com www.amerivap.com... -
Page 2: Important - Read First
• Do not use an extension cord in the bathroom or shower areas without taking special precautions. • Do not pull the cord or Steamax™ in a way that would cause the Steamax™ to unplug. • Do not move the Steamax™ by pulling or lifting it by its cord. - Page 3 The boiler is fitted with a safety cap which prevents the tank from being opened while there is still pressure inside. Do not plug in the Steamax™ or operate it if any of its components are damaged or if the Steamax™ leaks.
- Page 4 Steamax Parts FIGURE 1 1. Carry Handle 10. Steam Nozzle 2. Boiler ON Lamp 11. Small Round Brush 3. Power ON Lamp 12. Large Round Brush 4. Safety Cap 13. Rectangular Brush 5. Cord Winder 14. Elbow 6. Hose Plug 15.
-
Page 5: Control Panel
CONTROL PANEL Figure 2 A. Power ON light. It comes on when the Steamax™ is plugged in to indicate that the Steamax™ is connected into the power plug. B. Boiler heating switch. This switch light comes on to indicate that the boiler is powered up and heating up. - Page 6 Steamax™ is ready for use. Important: The Steamax™ unit requires power sockets and extension cords (if used) that are rated at 15A or higher. Insufficient voltage and current may damage the product.
-
Page 7: Fitting Accessories
Make sure that the safety panel fits into the slot on the topside of the panel. • Check, by pulling slightly, that the supply plug is correctly fixed into the Steamax™ socket. Steam nozzle (fit directly into grip) •... -
Page 8: Extension Tubes
FITTING ACCESSORIES (cont.) Extension Tubes Figure 9 • Slide the end of the extension tube on with the holes aligned until it clicks into place (Figure 9) onto the tool you will be using, making sure that the locking tab is in line with the hole. Figure 9 Figure 10 Floor cloth... -
Page 9: Cleaning With The Steam Nozzle
• To eliminate ground-in dirt, we recommend the use of small round brush, fitted to the steam nozzle. Important: The steam from the Steamax™ nozzle reaches a temperature of 220°F at the tip. When cleaning heat sensitive materials, hold the steam nozzle at least 4-5 inches from the surface. -
Page 10: Cleaning Glass Surfaces
How to Clean with the Accessories (cont.) Cleaning Glass Surfaces Figure 11 Figure 11 To clean glass, use the window squeegee as follows: • Press the steam switch. • Gently slide the squeegee over the glass with brush and its steam holes facing towards the surface. •... -
Page 11: Cleaning And Maintenance
DURING OPERATION A light (D, Figure 4) comes on to indicate that there is no water left in the tank. When this happens, the Steamax™ stops, and the boiler stops. To refill the boiler and continue cleaning, follow these steps: Press the upper boiler switch (B, Figure 2). -
Page 12: After Use
2. Unplug from the electrical outlet. 3. Before storing, wait until the Steamax™ cools down completely. If you do not intend to use the Steamax™ again within a few days, follow the steps below: 1. Press the upper boiler switch (B, Figure 2). The light on this switch goes off, indicating that the boiler is no longer powered up. - Page 13 • Kill Bed Bugs and Their Eggs • Clean Wheels • Kill Fleas and Their Eggs • Clean and Remove Tar • Clean Bird Cages Steamax™ makes cleaning more friendly for the environment and for you while saving time, energy and money!
- Page 14 • Makes homes cleaner • Makes cleaning more environmentally friendly The new revolution in cleaning and sanitizing! AmeriVap ® Systems, Inc. | 31 Successful Way, Dawsonville, GA 30534 Ph: 404.350.0239 | F a x: 404.350.9214 | Email: info@amerivap.com www.amerivap.com...
Need help?
Do you have a question about the Steamax and is the answer not in the manual?
Questions and answers