Kenwood KTC-V500N Instruction Manual page 4

Installation
Connection
• Make sure to ground the unit to a negative 12V DC power supply.
• If your car's ignition does not come with an ACC position, connect the ignition wires
to a power source that can be turned on and off with the ignition key. If you connect
the ignition wire to a power source that receives a constant voltage supply, as with
battery wires, the battery may die.
• If the fuse blows, first make sure that the wires have not caused a short circuit, then
replace the old fuse with one with the same rating.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the
car are working properly.
• Thoroughly wipe away oil and other dirt from the installation surface.
Please avoid installation on uneven surfaces.
Ignition key switch
–
+
Battery
(White)
4
ACC
Ground wire (Black) · (To car chassis)
Remove the protective sheet on
the black connector before the
KTC-V500N is connected.
(Black)
( 1A )
( 1A )
Ignition wire (Red) ª12V
(Accessory A)
UNIT MONITOR TO
(Accessory D)
INPUT ANTENNA TV