Theft Deterrent Faceplate - Kenwood KGC-9044 Instruction Manual

Other operations

Theft Deterrent Faceplate

The faceplate of the unit can be detached and taken with you,
helping to deter theft.
Removing Faceplate:
Press the release button and drop open the faceplate.
In its dropped condition, whilst drawing the faceplate to one
side, pull it to the front and remove it.
Release button
GRAPHIC EQUALIZER KGC-9044
SPE-ANA
1 S.A
2
9
PATTERN 4V
SPECTRUM
ANALYZER PREOUT
3
DISP MENU
SUBWOOFER LEVEL
ADJUSTABLE
60 120 250 380 500 750 1k 2k 4k 8k 16k
NOTE
• If the controls remain untouched for a period of 5 minutes or
more after the panel has dropped open or been removed, the
sound output stops automatically. (A warning beep starts
sounding 30 seconds before the sound output stops
automatically.)
• The faceplate is a precision piece of equipment and can be
damaged by shocks or jolts. For that reason, keep the
faceplate in its special storage case whilst detached.
• Do not expose the faceplate or its storage case to direct
sunlight or excessive heat or humidity. Also avoid places
with too much dust or the possibility of water splashing.
Reattaching Faceplate:
Hold the faceplate so that the
operation face faces the front
toward you and press until it
locks. The faceplate will be set
and the unit will be operational.
NOTE
When there is difficulty in setting
the faceplate, align the depression
on the left side of the faceplate
with the shaft of the unit, then
lock.
— 8 —
Shaft
Depression