Download  Print this page

Sanyo VSP-CB10 Instruction Manual

Coax-ssp converter.
Hide thumbs
   

Advertisement

INSTRUCTION MANUAL
COAX-SSP Converter
COAX-SSP-Umwandler
Convertisseur COAX-SSP
Convertidor COAX-SSP
Convertitore COAX-SSP
Before installing and using this unit, please read this manual carefully. Be sure to keep it handy for
later reference.
This unit converts coaxial signals to SSP signals, and also SSP signals to coaxial signals.
VSP-CB10
English
Deutsch
Français
Español
Italiano
GB
D
F
E
I

Advertisement

   Related Manuals for Sanyo VSP-CB10

   Summary of Contents for Sanyo VSP-CB10

  • Page 1 VSP-CB10 INSTRUCTION MANUAL COAX-SSP Converter English COAX-SSP-Umwandler Deutsch Convertisseur COAX-SSP Français Convertidor COAX-SSP Español Convertitore COAX-SSP Italiano Before installing and using this unit, please read this manual carefully. Be sure to keep it handy for later reference. This unit converts coaxial signals to SSP signals, and also SSP signals to coaxial signals.
  • Page 2: Main Features

    Disconnect the power cord immediately, dampness may get too high, or where there is a lot and consult your dealer (or a Sanyo Authorized of dust. Service Centre). Protect from high temperatures...
  • Page 3: Part Names

    Part names Be sure to turn off the power before changing the settings for any of the setting switches (1, 2 and 3). If you change a switch setting while the power is still turned on, the setting may not change correctly. 19200 POWER CONTROL SIGNAL...
  • Page 4: Connections

    Connections Note: Up to two COAX-SSP converters can be connected when making an SSP (RS-485) connection. If more than two units are connected together, delays may occur in SSP (RS-485) signal response and communication may not proceed correctly. After connecting, change the communication speed settings, alarm settings and address settings for the camera or multiplexer to match the settings for other peripheral equipment.
  • Page 5 Connections Operating a coaxial-type camera using a system controller This unit can convert SSP (RS-485) signals into coaxial signals, so that a coaxial-type camera can be operated using a system controller. Dome-type camera unit (PTZ) (sold separately) VIDEO IN connector CONTROL SIGNAL SEPA 19200...
  • Page 6 Connections The COAX-SSP converter can be secured by using bolts (M4) or nuts (M4) as described below. Installation example 1 (using bolts) Insert bolts into each of the two grooves on both sides of the converter. Bolt (M4) Installation example 2 (using nuts) Insert nuts into each of the two grooves on both sides of the converter.
  • Page 7: Specifications

    Specifications Camera input BNC termination Camera output BNC termination Operating environment Temperature: –10° C – 50° C Dimensions 123 (W) x 189.8 (D) x 46 (H) mm Weight Approx. 600 g Power supply 24 V AC/12 – 15 V DC: 100 mA 1.3 W LED illuminates when power supplied 189.8 (Unit: mm)
  • Page 8 SANYO Electric Co., Ltd. 1AC6P1P2465-- Printed in Japan L8ZBA/XE (0102KP-CZ)

Comments to this Manuals

Symbols: 0
Latest comments: