Advertisement
1.
Connect
Hose
and Gun (Refer
to
Fig 1.1
a.
Remove
the plastic
cap plug from
the filter
outlet
nipple and screw the 56 ft (15.2 m) fluid
hose onto the nipple.
b.
Connect
the whip hose between
the fluid hose
and the gun inlet connection.
c.
Don't
use thread
sealant,
and don't
install the
spray tip yet!
2.
Two
Gun
Hookup.
(Refer to Fig 1.1 Remove
the
plastic cap plug from the secondary
hose ball valve
and attach
an accessory
hose and gun.
CAUTION
To avoid
damaging
the pressure
control,
which
may result
in poor equipment
performance
and
component
damage,
follow
these precautions:
1.
Always
use nylon
spray
hose of at least
50 ft (15.2 m) long.
2.
Never
use
a wire braid hose as it is too rigid
to act as a pulsation
dampener.
3.
Never
install
any
shutoff
device
between
the filter and the main hose. See Fig 2.
4.
Always
use the main filter outlet
for one-
gun operation.
Never plug this outlet.
3.
Fill Packing
Nut/Wet-Cup
(See Fig 2.)
Fill the packing
nut/wet-cup
l/3
full with
Grace
Throat
Seal Liquid
ITSL),
supplied.
4.
Check
Electrical
Service
a.
Be
sure
the
electrical
service
is
120 V,
66 HzAC,
15 Amp
(minimum)
and that
the
outlet
you use is properly
grounded.
b.
Use an extension
cord which
has 3 wires of a
minimum
12 gauge
size, and a maximum
of
156 ft (45 m) long. Longer lengths
may affect
sprayer
performance.
5.
Plug
in the Sprayer
a.
Be sure the ON/OFF
switch
is OFF. Refer to
Fig 3.
b.
Plug the power
supply
cord into a grounded
electrical
outlet that is at least 20 ft (6 m) away
from the spray area to reduce the chance
of a
spark igniting
the spray vapors.
C.
Do not remove
the third
prong
of the power
supply
cord
plug,
which
is the
grounding
prong,
and do not use an adapter.
6.
Flush
the pump
to remove
the No.
10 motor
oil
which
was left in to protect
pump
parts after fac-
tory testing.
a.
Before
using
water-base
paint,
flush
with
mineral
spirits
followed
by soapy
water,
and
then a clean water flush.
b.
Before
using oil-base paint,
flush with
mineral
spirits only.
c.
See
"Flushing
Guidelines"
on
page
12 for
flushing
procedure.
Fig 1
1 HOSE
Fig
SECONDARY
FLUID HOSE
Fig 3
7.
Prepare
the paint
according
to the manufacturer's
recommendations.
a.
Remove
any skin that may have formed.
b.
Stir the paint to dissolve
pigments.
c.
Strain the paint through
a fine nylon mesh bag
(available
at most paint dealers) to remove
par-
ticles that could clog the filter or spray tip. This
is probably
the most
important
step
toward
trouble-free
spray painting.
307-607
9
Advertisement
