Operation - Grace Digital Schooners II GDI-AQSHR200 User Manual

SPEAKER (RECEIVER)
1. Connect the 12V power adaptor to the DC input jack on the bottom of
each speaker, then plug into the power wall outlet. You may also insert 6 x 'AA'
size ALKALINE batteries into the battery compartment. Ensure the batteries
polarity (+/-) are correct, at the bottom of the speakers
(batteries not included in the package).
2. Press the POWER button and turn the speakers ON. The POWER LED
will light up in blue. Switch off the speakers by pressing the POWER
button on the speaker, and the LED will turn off.

OPERATION

1. Turn on the audio source to which the transmitter is connected with.
2. Turn on the transmitter by set the POWER switch to ON position, and the
POWER LED on transmitter will light up
3. Select between the channels on the transmitter for best performance for the
location selected.
4. Press the "POWER" button on the speaker to turn on the speaker Press the
"SCAN" AUTO-TUNE button to get the best tuning reception on the speaker.
When the button is pressed, frequency tuning starts automatically and it stops
when a signal is detected. The POWER LED will illuminate steadily once
connected.
.
P.4