Index FGR-ST-DL210A User Manual page 12

FGR-ST-DL210A Fingerprint Door Lock
Deadbolt User Manual V4.0
C. The Administrator first gains access to the system.
D. Immediately after successfully unlocking the door (before the time out of the power); press
and hold the STOR button for 3 seconds (long beep will sound)
E. Press the Select button repeatedly to select the desired template ID number for the new
person. The display will show the next available IDs in each of the three groups. Remember
that Template IDs 1 thru 5 are Administrators, Template IDs 6 thru 10 are Supervisors and
Template IDs 11 thru 50 are Users.
For example, if only two Administrators have been registered, they will have used up template
positions 01 and 02. Upon registering a third person, pressing repeatedly on the Select button will
display: 11 - 06 - 03. These are the next available IDs in the all three categories.
If you wish this person to be at the Supervisor level, for example, you would cycle the three
available choices to 06, the next available ID number in the Supervisor category.
Note: The template ID number must be selected at this time. A fingerprint image cannot have its
management level changed after registering.
F. As you register each person keep record of their assigned #'s this way if you wish to delete
an individual at a later time-it will be by template ID number. A user Template ID list from is
provided at the end of this manual for your convenience.
G. Press STOR for about 3 seconds again, and have new registrant place finger firmly and
properly in scanning window. You will hear a long beep and see the scanning of the finger. At
the short beep, remove and replace finger onto window for a second scan.
H. When 2 beeps sound, that person's fingerprint was successfully registered.
The display should show 03 - 11 - 07. (The next available Supervisor ID is now 07, since you just
used up 06)
Guardian DL210A Operation Manual V4.0
ADMIN
SUPERVISOR
USER
12
Index
Access
1-5
6-10
11-50
© Copyright 2004 Index Security Inc.