Related Manuals for Kenwood KDC-C462
Summary of Contents for Kenwood KDC-C462
-
Page 1: Instruction Manual
KDC-C712 KDC-C662 KDC-C462 COMPACT DISC AUTO CHANGER INSTRUCTION MANUAL © B64-1381-00 (EF) -
Page 2: Safety Precautions
NOTE • If you have difficulty in installing this unit in your vehicle, contact your Kenwood dealer. • If it doesn't seem to be working properly, first press the Reset button. If the malfunction persists, consult your Kenwood dealer. -
Page 3: Handling Compact Discs
Handling compact discs Stains, scratches, or warping can cause skipping, malfunction, or low sound quality. Take the following precautions to avoid damage to the compact discs. • Avoid touching the recorded side (the side without the titles on) when you hold a compact disc. -
Page 4: Loading Compact Discs
Loading compact discs Projection Make sure the disc magazine is the right way up with the "disc" logo on the top.Pull the tray out by the projection. Place the disc on the tray with the label facing upwards. Insert the tray into the disc magazine until it locks. - Page 5 Connections "O" "N" O - N CAUTION • Do not connect the changer control cable while the control unit is turned ON. • Be sure to press the reset button after installation. • Do not install an antenna of radio equipment or distribute the antenna cable near the changer output cable, for this could cause malfunction with this unit.
-
Page 6: Installation
Installation Accessories Installation Procedure Removing the transportation screws Remove all 3 transportation screws for protecting the internal mechanism before you start to install the unit. NOTE After removing the transport screw, retain it carefully and attach it again before transporting the unit again. Angle adjustment switches •... - Page 7 Installation Horizontal installation KDC-C662/C462 Bottom view Vertical installation KDC-C662/C462 Bottom view In case of hanging in the trunk KDC-C662/C462 Bottom view KDC-C712 ø4 KDC-C712 KDC-C712 ø4 ø4...
-
Page 8: Troubleshooting Guide
Troubleshooting Guide PROBLEM Sound skips due to vibration. The disc changer mode cannot be selected. When removing the CD changer, be sure to first eject a magazine then unplug the changer cord. Do not forget to attach the transport screws before transporting the CD changer. The CD changer may be damaged during transport if a magazine or CD is left inside it or the transport screws are not attached.