Troubleshooting Guide; Specifications - Kenwood KDC-C462 Instruction Manual

Troubleshooting Guide

PROBLEM
Sound skips due to vibration.
The disc changer mode cannot
be selected.
When removing the CD changer, be sure to first eject a magazine then unplug the changer cord. Do not forget to
attach the transport screws before transporting the CD changer.
The CD changer may be damaged during transport if a magazine or CD is left inside it or the transport screws are not
attached.

Specifications

Specifications subject to change without notice.
Laser diode ..........................GaAlAs ( =780 nm)
Digital Filter ......................8 Time Over Sampling
D/A Converter ..............................................1 bit
Spindle speed ....................500 ~ 200 rpm (CLV)
Wow & Flutter ..............Below Measurable Limit
Frequency Response (±1 dB) ........5 Hz ~ 20 kHz
Total harmonic distortion (1 kHz)............0.005 %
Signal to Noise Ratio ..................................94 dB
Dynamic range ..........................................94 dB
Channel separation ....................................85 dB
8
POSSIBLE CAUSE
• The unit is mounted at a slant.
• Changer unit is mounted in an
unstable place.
• The angle adjustment switches are
set improperly.
The O-N selection switch of the disc
changer is not set properly.
• Mount the unit so that is level.
• Mount the unit in a stable place.
• Set the angle adjustment switches to
the correct positions.
Set the O-N selection switch to "O"
position.
Operating voltage ....14.4 V (11 ~ 16 V allowable)
Current consumption ........0.8 A at Rated power
Dimensions (W H
(KDC-C712) ......................250
(KDC-C662/C462) ............250
Weight
(KDC-C712)............................................2.0 kg
(KDC-C662/C462) ..................................1.8 kg
SOLUTION
D)
80 176 mm
64 176 mm