Programming The Oven - Amana AMH20 Service Manual

Programming Items
1. Oven must be ON.
• Press PREHEAT ON/OFF.
• ITEM must flash in display. If not, open and close oven door.
2. Press PROGRAM SAVE.
3. Press pad to be programmed or reprogrammed.
4. Press TIME ENTRY to program amount of cooking time.
• Enter desired cooking time by using numeric keypad.
• The total microwave cooking time (all stages combined) is 20 minutes.
5. Press and hold TEMP ENTRY to program the radiant heater. HTr shows in the
display. Radiant heater setting automatically defaults to 9 (highest).
• Set radiant heater by pressing pads 0 through 9.
• Pad 1 is the lowest heater setting; pad 9 is the highest heater setting. 0 turns off
radiant heater.
6. Press and hold POWER LEVEL to program fan speed. FAn shows in the display.
Fan speed setting automatically defaults to 9 (fastest).
• Set fan speed by pressing pads 1 through 9.
• Pad 1 is the slowest fan speed; pad 9 is the fastest fan speed.
7. Press POWER LEVEL to program level of microwave power. Power level
automatically defaults to High (100%).
• For a lower microwave power, press pads 1 (for 10%) through 9 (for 90%). 0
turns off microwave power.
8. If stage cooking is desired, press STAGE.
• Enter cook time, radiant setting, fan setting, and power level for each stage by
repeating steps 4-8.
• To enter another cooking stage for that pad, press STAGE pad again. Up to
four different stages can be programmed for a total of 20 minutes microwave
cooking time.
9. Press the PROGRAM SAVE pad to save the programming into the pad.
©2006 Maytag Services

Programming the Oven

What is stage cooking?
Stage cooking enables up to four different
cooking cycles, or stages, to be used
consecutively without repeated input from the
user.
Example of Stage Cooking Conditions
Stage 1 Stage 2
Temp
250°C 250°C
Power
H (high)
Time 2:30 1:30
Heater
9
Fan 9
16023463
Stage 3 Stage 4
250°C 250°C
3 0 0
1:30 1:00
9 5 5
9 5 5
A–11