Summary of Contents for Unifire Saw
- Page 1 High Performance Ventilation Chain Saws 3924 E. Trent Ave. Spokane, WA 99202 (509)535-7746 (509)535-9064 1-800-745-3282...
- Page 2 Air Filter adjusted. Spark Plug Refuel and start the saw. Check carburetor settings. Tensioning the recoil spring Changing recoil spring Do not use the saw until sufficient chain oil has Carburetor reached the chain. Daily maintenace Weekly maintenance Monthly maintenance...
-
Page 3: Start And Stop
WARNING! Never start the saw engine without the bar, chain and clutch cover assembled. Always move saw away from fueling area. Place the saw on clear ground, and make sure you have secure footing Page 2... -
Page 4: Fuel Handling
Use good quaility un- leaded gasoline. max one months supply of fuel. The lowest recommended If the saw is not used for octane rating is 87. sometime the fuel tank should be emptied and When working at continu- ous high revs a higher cleaned. -
Page 5: Mounting Guide Bar And Chain
Assembly and Maintenance Hold up the tip of the bar Mounting Guide Bar and Chain and tighten the chain. The Always wear gloves when working with the chain is correctly chain, in order to protect your hands from injury! tensioned when there is no slack on the underside of the bar, but it can still Check that the chain... -
Page 6: Spark Plug
Maintenance 3 Stage Air Filtration Changing a broken starter cord Loosen the screws, that hold The air filter must be regularly cleaned from the device against the crank- dust and dirt in order to avoid: case and remove the starter - Carburetor malfunctions device - Starting problems... -
Page 7: Fine Adjustment
The high speed needle H is correctly set when the saw “4-cycles” a little. If the saw “whistles” the setting The fuel quantity required in relation to the air flow, is too lean. If there is too much exhaust gas at the provided by opening the throttle, is adjusted by the L time as the saw ”4-cycles”... -
Page 8: Daily Maintenance
If and binding occurs, or if engine fails to 2. Lubricate the clutch drum return to idle, the saw bearing. should be taken to your dealer before it is used 3. File off burrs, if any, on again. - Page 9 Depth Guage Installation Depth Guage Installation Instructions 6. Plunge the gauge TOOLS REQUIRED: several times to check for 1/2 inch wrench (or 13mm) binding. Use a spray Loctite 272-(provided) lubrication such as WD 40 17/64 Drill Bit for easy sliding. Center Punch 1.
- Page 10 Depth Guage Instructions 4. Once the cut has been started move saw to a 90 Depth Guage Instructions degree angle to achieve a precise cut at desired depth. The depth guage is spring loaded. For a standard cut, simply push saw bar and chain into cut area, the Corrugated Roofs guage will automatically slide back.
- Page 11 Unifire Pro-Saw Parts What is it? 15. Saw bar 1. Cylinder cover 16. Bumper 2. Front Handle 17. Chain catcher. Catches chain if it jumps or 3. Starter Cover breaks. 18. Clutch cover Chain oil tank 5. Starter Handle 19. Right hand guard.