Arrow X2-Cadet User Manual

SEAT POSITION CHART
X2-CADET / ROOKIE
SMALL DRIVER
28KG-130 CM TALL
A B C
MS 100 240 95
Use
KSE15D
seat
bracket
MRC
N/A N/A N/A
NOTES:
- All dimensions refer to Kartech 'RT' type seats only
- All above measurements are with the rear axle in 920 centre position and chassis in high
position (axle low)
MEDUIM DRIVER LARGE DRIVER
35KG-138CM TALL 40KG-147CM TALL
A B C A B C
60 215 120 N/A N/A N/A
50 215 110 40 215 105
ASSEMBLY NOTES
Arrow self-aligning seat washers:
The Arrow karts are supplied with Arrows unique self-centring seat washer
system. Fitting between the chassis seat supports and seat, these washers
insure there are no torsional loads placed on the seat through mis-
matching angles between the seat and the chassis. The seat does have an
influence on the handling characteristics of the kart as it is an important
torsional member on a karts chassis structure. As such, the Arrow self-
aligning seat washers are major asset in alleviating pre-loads within the
kart. (See diagram above).
'SL
Tyre.
Eg.
Dunlop
SL1
SUGGESTED STARTING SET-UP
FRONT CRASH BAR: Loose
REAR CRASH BAR: Tight
REAR RIDE HEIGHT: High (axle low in kart)
REAR TRACK: 1105 (ONLY MOVE IN 5MM INCREMENTS)
REAR AXLE TYPE: Standard
FRONT RIDE Central
HEIGHT:
FRONT TOE: 2mm OUT Overall
FRONT TRACK: 10mm (ONLY MOVE IN 5MM INCREMENTS)
FRONT CASTER: Central, both lines pointing back
FRONT CAMBER: 2mm POSITIVE Overall
FRONT TORSION Removed
BAR:
SIDE POD BARS: Loose
REAR HUB LENGTH: 50mm
ACKERMAN: Middle, top hole on stub arm