Specifications - WaterMAXX WWD224W-2 Use & Care Manual

IMPORTANT: Collect the water in a container, not the drip tray. Replace the drain cap and hand tighten only.
3. Replace the water bottle (see Installing the Water Bottle on pg. 3).
Cleaning the Inside of the Dispenser
To prevent mineral deposits that can affect the taste and flow of the water, and
to ensure proper product performance, your water dispenser must be cleaned
every 4 months.
1. Unplug the power cord.
2. Remove the water bottle and bottle support collar.
3. Drain the reservoir (see Draining the Reservoir on pg. 5).
4. Pour a vitapur® water dispenser cleaner or a mixture 4 cups / 1L of
vinegar with 4 cups / 1 L of hot water into the reservoir and wait 20
minutes. If using a water dispenser cleaning solution, please follow the
manufacturer's instructions.
IMPORTANT: To avoid water overflow while cleaning the dispenser,
always remove the bottle support collar before pouring water or a cleaning
solution into the reservoir (see Figure A on pg. 3).
5. Press both dispensing taps until water no longer comes out.
IMPORTANT: Collect the water into a container, not the drip tray.
6. Rinse with clean water and drain (see draining the reservoir).
7. Replace the bottle support collar and the water bottle (see Installing the Water Bottle on pg. 3).
IMPORTANT: Drain approximately 4 glasses of water from each tap before initial use. This does not need to be
done with replacement bottles.
Going Away on Vacation
When not using the dispenser for long periods of time or when going on vacation, unplug the dispenser and drain the
reservoir (see Draining the Reservoir on pg. 5). Follow Initial Product Cleaning Procedures upon return and startup of
the dispenser.

SPECIFICATIONS

WWD224W-2
Output per hr:
Internal Tank:
Cooling Temp (approx.):
Power Consumption:
Cold 0.5 gal / 2.0 L
Cold 0.8 gal / 3.2 L
8°C / 46°F
Cold 80 W
Cleaning Kit
Available online at
www.greenwayhp.com
6