EasyFire EF4001B AutoLite Installation & Operating Instructions Manual

Please read this entire manual before installation. Save these instructions.
SAFETY NOTICE
CAUTION: HOT W HILE IN OPERATION. KEEP
CHILDREN, CLOTHING AND FURNITURE AW AY.
CONTACT M AY CAUSE SKIN BURNS.
IF THIS HEATER IS NOT PROPERLY INSTALLED,
A HOUSE FIRE M AY RESULT.
CONTACT LOCAL BUILDING OFFICIALS ABOUT
RESTRICTIONS AND INSTALLATION INSPEC-
TION REQUIREM ENTS IN YOUR AREA.
FAILURE TO COM PLY W ITH OW NERS' M ANUAL
INSTRUCTIONS W ILL VOID YOUR W ARRANTY!
NOTE: This heater should not be installed in
a bedroom or bathroom.
INSTALLER: PLEASE LEAVE THIS MANUAL WITH THE OWNER!!
Sierra Products, Inc.
5061 Brooks St., Ste B
Montclair, CA 91763
(909) 399-3355
EF4001B AutoLite Pellet Stove Insert
Installation & Operating Instructions
PLEASE READ THIS ENTIRE M ANUAL BEFORE
INSTALLATION AND USE OF THIS PELLET FUEL-
BURNING ROOM HEATER. FAILURE TO FOLLOW
T H ES E

GENERAL INFORMATION

Installation and repair should be done by a qualified
service person. The heater should be inspected before use
and at least annually by a professional service person. More
frequent cleaning m ay be required due to fuel quality,
excessive lint from carpeting, bedding m aterial, etc. It is
im perative that control com partm ents, burn pot and circulat-
ing air passageways of the heater be kept clean.
The EASYFIRE Pellet Insert has been designed and
approved for burning w ood pellet fuel only. Burning solid
fuel in other form s is not perm itted and will void all warran-
ties.
This unit has been approved for use with a Ø 3" Type L
Pellet Vent System or Stainless Chimney Liner (Ø 4" on
runs 10 feet and above).
NEVER use gasoline, gasoline-type lantern fuels,
kerosene, charcoal lighter fluid, or sim ilar liquids to start or
"freshen up" a fire. Keep all such liquids well away from the
heater while it is in use.
Ashes m ust be disposed of in a m etal container with a
tight fitting lid and placed on a noncom bustible floor or
ground, well away from all fuels, pending final disposal.
NOTE : During the first few burns the high tem perature
paint and sealant used in m anufacture will em it som e odor
and sm oke. Open doors and windows to the outside for
proper ventilation during the first burn cycle and curing of
the paint.
This heater, when installed, m ust be electrically grounded in
accordance with local codes or, in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70-
2006.
IN S T R U C T IO N S C O U L D
Listed by OMNI-Test
Laboratories, Inc.
Report No. 256-S-01-4
R E S U L T IN