Video Recording; Taking Photos; Connect To Your Computer; Charging - Spycrushers Operation Manual

SPYCRUSHERS CAR KEY CHAIN SPY CAMERA

Video Recording

To record video turn on the Car Key Chain Spy Camera. Once on,
press and hold the Video/Camera button until the indicator light
flashes repeatedly 3 times and stops. You are now recording video. To
stop recording simply press the Video/Camera once quickly.

Taking Photos

To take photos turn on the Car Key Chain Spy Camera. Once on, press
the Video/Camera button once quickly, the indicator light will flash
once taking one photo. Repeat process to take more photos.

Connect To Your Computer

While the Car Key Chain Spy Camera is off or in standby mode it can
be connected to your computer using the USB Cable. Plug the USB
Cable connector into the Car Key Chain Spy Camera and the other
end into your computer. The Car Key Chain Spy Camera will be listed
as a "Removable Disk". Within two files folders will hold images or
video. Once connected the Car Key Chain Spy Camera will upload its
data to your computer, the yellow status indicator light will blink
quickly. To disconnect safely please click "Safely Remove Hardware
and Eject Media" icon on the right bottom corner of your task bar.
Then click the "Eject" choice and unplug the USB cable from both
your computer and Car Key Chain Spy Camera.

Charging

Connect the Car Key Chain Spy Camera to your computer using the
USB Cable. When the battery charging you will see the yellow status
indicator light blinking slowly. The battery is fully charged when the
yellow light stops blinking. Note: If the yellow indicator light
continues to blink after120 minutes disconnect and use normally. The
Car Key Chain Spy Camera can be charged at anytime, but for
maximum battery life please use battery until completely drained and
fully recharge to its capacity for the first five times.
Operation Manual
w w w . s p y c r u s h e r s . c o m page 3