Editing During Dubbing (Only At Normal Speed) - Tascam 202MKVI Owner's Manual

NOTE
High-speed dubbing makes a copy at approximately two times
the normal speed. We recommend normal speed dubbing for
best audio quality.
During dubbing, either the
steadily on the display.
During normal speed dubbing, only the following keys work:
TAPE 1 deck : STOP (H)
TAPE 2 deck : PAUSE, REC MUTE, STOP (H)
During high-speed dubbing, only the STOP (H) key works.
Neither DUB START key works immediately after the tape is fast-
forwarded or rewound to the end. Wait for 5 seconds or more
before pressing the key.
NOTE
o During dubbing, the pitch control does not work.
o Recording level adjustment is not necessary for dubbing, as
the recording level is set to the level of the pre-recorded tape.
Operating the INPUT control, before or after starting dubbing, has
no effect at all.
o If a nearby television set is switched on during high-speed dub-
bing, a high-pitched interference noise may be recorded on the
tape. To avoid this, either perform dubbing at normal speed, or
turn off the television.
20
Recording (continued)
NORM DUB or HIGH DUB indicator lights

Editing during dubbing (only at normal speed)

You can prevent unwanted songs or unnecessarily long blanks from
being dubbed, or you can create blanks between songs.
1. At the desired point during dubbing, press the PAUSE key
on the TAPE 1 deck. The TAPE 2 deck only enters the pause
mode, allowing you to let unwanted songs go by.
To create a 4-second blank between songs, press the REC MUTE
key on the TAPE 2 deck. The TAPE 2 deck temporarily stops after
recording no signal for 4 seconds.
The TAPE 1 deck continues playback when the TAPE 2 deck is in
pause mode.
2. To resume dubbing, press the PAUSE key on the TAPE 2
deck.