Installation; Air Supply - DeWalt DWMT70773L Instruction Manual

INSTALLATION

Air Supply

The recommended hook-up is shown in Figure A. Pneumatic tools
operate on a wide range of air pressures. For maximum efficiency
and longer tool life, the pressure of the air supplied to these
tools MUST not exceed the rated PSI at the tool when the tool is
running. Using a higher than rated pressure will cause faster wear
and drastically shorten the tool's life. A higher air pressure can also
cause an unsafe condition and explosion.
The inside diameter of the hose should be increased to
compensate for unusually long air hoses (over 25 feet).
Minimum hose diameter should be 3/8" I.D. and fittings should
have 1/4" NPT thread.
The use of air line lubricators and air line
filters is recommended to prevent water in
the line that can damage the tool. Drain the
air tank daily. Clean the air inlet filter screen
on at least a weekly schedule to remove
accumulated dirt or other matter that can
restrict air flow.
The tool's air inlet used for connecting
an air supply has standard 1/4" NPT
American thread.
Safety Rules For Pneumatic Tools
1) Inspect the air hose for cracks or other problems.
Replace the hose if worn.
2) Never point an air hose at another person.
3) Disconnect the tool when not in use, or before performing
service or changing accessories.
4) Use proper hoses and fittings. Never use quick change
couplings attached to the tool. Instead, add a hose and
coupling between the tool and the air supply.
Figure A
Tool
Air Hose
Leader Hose
11
1/2"(or larger)
Pipe and Fittings
Coupler
Oiler
Nipple
Filter
Drain Daily