Advertisement
BEPORE USING WATER FROM YOUR WATER PURIFIER FOR THE FIRST TIME
continued from page 4
12.
Stearowillcontinuetopassthroughforafewmin-
water which may have some harmless carbon
utes. After unit cools, rinse out kettle,
tines (very fine black particles) in it fromthe filter.
13.
Shake the carafe, then discard the first batch of
MAKING PURIFIED WATER
1.
Set the Purifier on your countertop or table.
6.
Plug the power cord into any 120 volt outlet.
2.
Unplug the kettle from the base (Figure 1). Twist
the cover counter-clockwise
to remove, and set
aside.
3.
Rinse and fill the ketfie with tap water up to the
max. fill line.
NOTE:
You can pudfy less than the full amount. Use
this chart as a guide. DO NOT fill the kettle over the
max. fill line because the carafe will overflow.
WHEN YOU FILLWlTH
THE CYCLE TAKES
TAP WATER TO...
Model 344800 (3 qt.)
5 hours
Modet 3448"t0 (1 gallon)
4 hours
4.
Replace the cover on the kettle.
Twist cover
clockwise to lock. Plug the kettle into the base
unit.
Carry carefully and keep level to prevent
splashing.
7.
Press the reset or start button. The red indicator
light will illuminate.
WhenthecyclaisoverthePurifiertumsoffautoroa_cal-
ly. AFTER THE FAN MOTOR GOES OFF, WAIT AT
LEAST 30 MINUTES
BEFORE
REMOVING
THE
COVER...
WARNING:
NEVER REMOVE THE COVER WHILE
THE FAN MOTOR IS RUNNING,
OR FOR 30 MIN-
UTES AFTER IT STOPS.
YOU COULD GET SE-
VERE BURNS FROM THE BOILING
WATER OR
STEAM.
B.
To pour water from carafe, open spout by pulling
on center stdp in direction of the arrow indicator
near thumb position.
9.
Store the carafe filled with product watar in the re-
frigerator until you need it.
5,
Set the carafe into place on base unit,
CARE
AND CLEANING
OF YOUR
WATER
PURIFIER
10. After the Purifier has ccoled (wait for 30 roinutes
after the fan motor stops running) remove the
kettle to clean.
KEI-rLE
After each use, dnse theinside with lukewarm tap water
and remove any residue. Clean by wiping out the inside
of the kettle with a damp cloth and rinse. If a deposit
starts to form at the bottom, use Kenroore Water Pudfier
cleaner (see page 7). ReSidue build up on the bottom
of the kettle will prevent the system from purifying
a complete batch of water. Remove the kettle from
base unit. Fill kettle at the sink wfth hot water and follow
the instructions
on the cleaner boffie. Rub with a soft
scouring pad and rinse thoroughly.
CAUTION:
DO NOT IMMERSE THE PURIFIER OR
KETTLE IN WATER.
CARAFE
Clean with mild dish detergent and soft cloth. Rinse
thoroughly with water.
CLEANING
EXTERIOR SURFACES
TO keep your Purifier looking new, you should paded-
icafly clean the exterior plastic surfaces with a soft,
damp cloth. DO NOT use any caustic cleaning solu-
tions, scoudng pads or powder because they will
damage the plastic finish.
NOTICE
J
THERE ARE NO USER SERVICEABLE
PARTS
INSIDE THE UNIT.
CHANGING
THE CARBON RLTER
IMPORTANT: The purifier uses a carbon filter in the ca-
rafe cover to remove traces of odors before the purified
water is collected in the carafe. The filters last about 2-3
months. A retum of unwanted odor means the tilter
should be replaced. Order replacement carbon filters
from Sears (see page 7).
continued, page 6.
5
Advertisement
