Page 1
To better help you obtain assistance or service should you ever need it, write down the following information about the product. This information is on the identification label located on the left hand inside wall of the cabinet. We advise you to keep this Owners Manual and sales slip in your possession.
Page 2
WARNING MAKE SURE THE REFRIGERATOR IS DISCONNECTED FROM THE POWER SUPPLY BEFORE ANY SERVICE. PRESS THE REFRIGERATOR SWITCH TO THE “OFF” POSITION THEN UNPLUG THE POWER CORD FROM THE ELECTRICAL RECEPTACLE. ALL SERVICE WORK MUST BE PERFORMED BY A CERTIFIED TECHNICIAN ONLY.
• Door switch not working. • Check door switch. This warranty does not extend to any consequential damage caused by the failure of the product under any circumstance and further, Minus Forty ® Technologies Corp. shall not be responsible for damage to the contents of the product or any...
TROUBLESHOOTING GUIDE INSTALLATION INSTRUCTIONS for online reference go to www.minusforty.com WARNING This refrigerator MUST be installed on a dedicated grounded circuit protected with a 15 Amp circuit breaker WARNING or a 15 Amp time delay fuse. Do not remove ground prong. If the cord or plug is damaged, replace with the Make sure the refrigerator is disconnected from the power supply before any service.
INTERIOR LED STRIP REPLACEMENT OPERATING INSTRUCTIONS WARNING WARNING Check with your power company if you are not certain of your power supply. Make sure the refrigerator is disconnected from the power supply before any service. Press the Before connecting to power supply the refrigerator should be upright and idle for at least 1 hour. refrigerator switch to the “Off”...
CONDENSER CLEANING TEMPERATURE ADJUSTMENT AND SWITCH FUNCTIONS The refrigerator is designed for minimal condenser cleaning. With the “lint free” condenser design, Locate the electronic control at the lower front of the refrigerator. The electronic control displays the most dust and dirt will pass right through the condenser. To insure the proper operation, we recom- actual temperature inside the refrigerator.
CONTROLLER ALARMS AND SIGNALS CONT... CLEANING WARNING Message Cause Action To reduce the risk of fire, electrical shock or personal injury, disconnect the refrigerator from the StArt dELAy Start up delay in progress • Wait for 6 minutes power source before cleaning. Press the refrigerator switch to the “Off” position, then unplug the power cord from the receptacle.
Need help?
Do you have a question about the 07-CSGR and is the answer not in the manual?
Questions and answers