Chapter 3: Dvr Connection; Hdd Installation; Camera And Monitor Connection; Power Supply Connection - Valueline SVL-SETDVR30 Manual

3�1 HDD Installation
Caution: Please do not Install or take out hard drive when DVR is running!

HDD Installation:

(1) Cut power firstly, and then remove screws and open DVR upper cover carefully;
(2) Insert Power Cord and data cable into Pin of hard drive securely;
(3) Remove the screws on the HDD bracket; fix the HDD to the bracket and then fix the bracket
with HDD to DVR body;
(4) Put the upper cover back carefully, re-attach screws.
Note: If user requires higher performance HDD, strongly recommend you use special hard
driver for security and protection.
3�2 Camera and Monitor Connection
Connect camera cable to video input of DVR, and from video output of DVR to Monitor via
BNC connector (Refer to section2.2-Rear Panel); or
If the camera is a PTZ speed dome, you could connect RS485 A & B to the according port of
DVR respectively (refer to system figuration on Chapter 8).
3�3 Power Supply connection
After power on please make sure the video I/O connection well, audio device with BNC cable.
4�1 System Initialization
Picture 4-1

Chapter 3: DVR CONNECTION

Chapter 4: DVR Boot up

After connecting the Power cable of DVR to wall
outlet and pressing the Power button on the front
panel, you will enter into the system initializing
screen shown as Picture 4-1.
10
ENGLISH