Table of Contents
Advertisement
Quick Links
Dual CameraLink
PCI Image Grabber
ISG Part Number:
Users Guide
PIM00004 Revision 1.00
Imaging Solutions Group of New York, Inc.
7243 Hertfordshire Way
Victor, New York 14564
Copyright 2003 Imaging Solutions Group of New York, Inc., All Rights Reserved
ISG
TM
DKT-0010-IG (XLX500K)
Subject to Change Without Notice
1
Advertisement
Table of Contents
Summary of Contents for ISG Dual CameraLink DKT-0010-IG XLX500K
- Page 1 Dual CameraLink PCI Image Grabber ISG Part Number: DKT-0010-IG (XLX500K) Users Guide PIM00004 Revision 1.00 Imaging Solutions Group of New York, Inc. 7243 Hertfordshire Way Victor, New York 14564 Copyright 2003 Imaging Solutions Group of New York, Inc., All Rights Reserved...
- Page 2 This board receives Gray level digital data from digital sources, such as the ISG Imager modules and ports the information to a PC host memory or off-board display memory for further evaluation, analysis and display.
- Page 3 Signal Short Description Name Name Pixel data: PA0-7 Port A,B and C are logical 8 bit words. Port A, B & PB0-7 They define how the data is PC0-7 multiplexed. Frame Valid FVAL Frame valid is defined HIGH for valid lines.
-
Page 4: Hardware Installation
Modules. The communication protocol has been developed by ISG, which supports 115200 Baud, with one start bit, one stop bit and no handshaking. The provided ISG Graphical User Interface (GUI) software sets up the Imager Module parameters via this communication link through the ISG CameraLink Frame Grabber board. -
Page 5: Software Installation
At this point, you should click on Cancel because the driver will be installed during the installation of the ISG Image Grabber software. Software Installation Please refer to the Software Installation Guide for detailed information. - Page 6 CameraLink Connector (“A” or “B”) This Board-to-cable connector supports CameraLink Base Configuration Industry Standard Interface. It is a 26-position SMT connector with two Screw Locks (One at each side of the connector) to tightly secure a CameraLink cable. § CameraLink Connector part number: 3M 10226 –...
- Page 7 CameraLink Connector Pin assignments Imager Frame Grabber Signal Name Cable Name Connector Connector Inner Shield Inner Shield Inner Shield Inner Shield PAIR1- PAIR1+ PAIR2- PARI2+ PAIR3- PAIR3+ XCLK- PAIR4- XCLK+ PAIR4+ PAIR5- PAIR5+ SerTC+ PAIR6+ SerTC- PAIR6- SerTFG- PAIR7- SerTFG+ PAIR7+ CC1- PAIR8-...
Need help?
Do you have a question about the Dual CameraLink DKT-0010-IG XLX500K and is the answer not in the manual?
Questions and answers