Bryant 345MAV User's Information Manual page 7

Condensing gas furnace
Table of Contents

Advertisement

furnace air filter be checked every 3 or 4
weeks and cleaned if necessary.
If installed with factory-specified dis-
posable media filter, check or replace fil-
ter before each heating and cooling
season. Replace disposable media filter
at least once a year.
The air filter is normally located in the
blower compartment. (See Fig. 2.)
If air filter has been installed in another
location, contact your dealer for instruc-
tions. To inspect, clean, and/or replace
the air filter(s), follow these steps:
1. Turn off electrical supply to the
furnace. (See Fig. 16.)
2. Remove main furnace door.
(See Fig. 18.)
3. Remove blower access panel.
(See Fig. 19.)
NOTE:
It will be necessary to remove
2 screws.
4. Remove air filter from furnace.
• AIR FILTER(S) LOCATED IN
END OF FURNACE:
a. Slide filter retainer sideways until
it is free of latch. (See Fig. 20.)
b. Slide air filter out of furnace.
(See Fig. 21.)
• AIR FILTER LOCATED IN SIDE
OF FURNACE:
a. Remove filter retainer from latch.
(See Fig. 22.)
b. Gently remove air filter and care-
fully turn the dirty side up (if
dirty) to avoid spilling dirt from
the filter. (See Fig. 23.)
18
19
7
5. Inspect the filter. If torn, replace it.
NOTE:
If washable filter that was
shipped with the furnace has been
replaced with an electronic air cleaner
(EAC), refer to the EAC Owner's Man-
ual for maintenance information.
6. If washable filter, wash filter (if
dirty) in a sink, bathtub, or outside
with a garden hose. Always use
cold tap water. A mild liquid deter-
gent may be used if necessary.
Spray water through filter in the
opposite direction of airflow.
20
Allow filter to dry.
7. Reinstall clean air filter.
8. Reinstall filter retainer.
9. Replace blower access panel and
main furnace door. Be sure to
replace 2 screws in blower access
panel. (See Fig. 24 and 25.) Turn
on electrical supply to the furnace.
21
If your furnace air filter needs to be
replaced, be sure to use a factory autho-
rized filter of the same size that was
originally supplied. Use the furnace fil-
22
ter table and compare your furnace size
with the proper filter size.
FURNACE AIR FILTER TABLE
FURNACE
CASING WIDTH
FILTER SIZE*
(IN.)
(IN.)
17-1/2
(1) 16 x 25 x 1
21
(1) 20 x 25 x 1
24-1/2
(1) 24 x 25 x 1
* Furnace with a side return-air inlet may have a dif-
ferent filter size. Measure the filter to obtain the
correct size.
23
24
25
FILTER TYPE
Cleanable
Cleanable
Cleanable

Advertisement

Table of Contents
loading

Table of Contents