Lenovo D1960 Technical Information page 8

Wide monitor
Hide thumbs Also See for D1960:
Table of Contents

Advertisement

800 x 600
800 x 600
1024 x 768
1024 x 768
1024 x 768
1360 x 768
1366 x 768
• User modes: 20
The factory-preset modes cannot be overwritten, but can be adjusted to personal
choice. The new settings are stored automatically in one of the user locations and
are recalled each time that mode is used. The factory settings for the mode in use, if
any, can be restored by operating the reset control.
Information about the current incoming display mode is shown in the on-screen
displays. However, it is displayed at the LCD panel's optimum refresh rate of 60 Hz.
It may be necessary to make some adjustments to the displayed image to
compensate for variations in video signal timings. The user controls can be used to
make these adjustments.
Compatibility
The Lenovo D1960 Wide monitor is supplied with a detachable 1.5-meter video
signal cable. This cable has the widely used 15-pin, D-Sub video connector for
system unit connection.
This monitor has been tested with Lenovo 3000 systems and is compatible with
systems and graphics adapters which comply with the relevant parts of "VESA and
industry standards and guidelines for computer display monitor timing" Version 1.0
Revision 0.8, adopted September 17, 1998. Supported display modes and number of
colors are a function of the attaching system unit. The full range of display modes,
refresh rates, and number of colors available with this monitor may not be available
or supported with all combinations of system units, their operating systems, and
application software. Implementation of monitor Plug and Play follows the VESA
DDC standard. This standard must also be implemented in the attaching system unit
hardware and software to be effective.
Limitations
• Supported display modes are a function of the attaching system unit and video
subsystem. The full range of display modes available with these monitors may not
be available or supported with all combinations of system units, their operating
systems, video adapter cards, and application software.
• Horizontal- and vertical-synchronization signal timings are critical in order to
achieve acceptable screen images. As a consequence, support for all possible
variations in H- and V-sync timings for any display mode cannot be assumed.
• Adjustment of the user controls to enlarge the image to its maximum size requires
that the signal timings of the display mode being used fall within the monitor-
timing specifications.
• The number of colors shown in any display mode will be 16.7 million and is
dependent on the capabilities of the video adapter in the system unit.
• The Lenovo D1960 Wide provides FCC class B - residential installation -
compliance in all display modes.
• Implementation of monitor power management follows the VESA DPMS standard.
This standard must also be implemented in the attaching system unit hardware
and software for monitor power management to be effective. The system
implementation must provide user-adjustable, power-down delay periods. The
monitor power management function is invoked only after appropriate signals are
received from an attached system unit or video adapter.
• Implementation of monitor Plug and Play follows the VESA DDC standard. This
standard must also be implemented in the attaching system unit hardware and
software for monitor Plug and Play to be effective.
Lenovo Latin America Hardware
Announcement LG09-0288
72 Hz
75 Hz
60 Hz
70 Hz
75 Hz
60 Hz
60 Hz
Lenovo is a registered trademark of Lenovo Corporation
8

Advertisement

Table of Contents
loading

Table of Contents