Zenith Z-100 Series User Manual page 2

Regulatory and Registration Information
WARNING - This equipment has been certified to comply within the limits established for a
Class B computing device, pursuant to Subpart J of Part 15 of the rules established by the
FCC. Only peripherals (computer input/output devices, terminals, printers, etc.) certified to
comply within these Class B limits may be attached to this computer. Operation with non-certified
peripherals is likely to result in interference to radio and TV reception.
This equipment generates and uses radio frequency energy for its operation; and if not properly
installed and used, that is, in strict accordance with the instructions in this manual, may cause
interference to radio and television reception. It has been type-tested and found to be within the
RF emission limits for a Class B computing device which is intended to provide reasonable
protection against such interference in a residential environment. However, there is no
guarantee that interference will not occur in any particular environment or location. If this
equipment does cause interference to radio and television reception, which can be determined by
turning this equipment on and off, try to correct the interference by one of more of the following
measures.
•
Move the computing device away from the equipment receiving the interference.
•
Relocate the computing device with respect to the receiver.
•
Reorient (turn) the antenna of the receiving equipment.
•
Plug the computing device into a different AC outlet so that the computing device and
receiver are on separate circuits from the fuse or circuit breaker box.
•
Disconnect and remove any input/output cables that are not being used since unter-
minated input/output cables are a potential source of high RF emission levels.
•
Unplug and remove any serial input/output circuit board cards that are not being used
since unterminated cards can be a potential source of interference.
•
Make sure that the computing devices are plugged into grounded outlet receptacles.
Avoid using AC two- to three-wire cheater plugs. Lifting or removing the power cord
ground may increase RF emission levels. Removing the ground circuit also may cause a
lethal shock hazard to the user.
If you need additional help, consult your dealer or ask for assistance from the manufacturer. You
may also find the following booklet helpful: How to Identify and Resolve Radio-TV Interference
Problems. This booklet is available from the U.S. Government Printing Office, Washington, DC
20402, stock number 004-000-00345-4.
Registration
To receive the full benefits of your warranty, complete and mail the accompanying registration
card. Also, record the series and serial numbers of your equipment below. Refer to these
numbers in any correspondence you have with Zenith Data Systems regarding this equipment.
Model
Series
Place purchased ____________________________________________________________
Any attempt to alter or modify the design, or to use this device in a manner other than described in
this manual, will void the warranty and release the manufacturer from any responsibility for its
operation.
Serial Number ___________________________
Date purchased _________________________