Table of Contents
Advertisement
In the "48" position, 48 Phantom microphone power is being applied to that input
XLR connector. Please note that you should only use the "48" setting when
powering microphones that are designed to operate from 48PH power. If you
want to power up older Sennheiser "T" power microphones, you will need to use
a PSC 48PH to 12T adapter barrel (part # FPSC0010A, available from any PSC
dealer). Please also note that 48PH is not needed or compatible with most
wireless receivers.
If using wireless, turn that input's microphone
powering switch to "D".
Dedicated Line Outputs
Each of the six inputs found on the PSC ProMix 6 audio mixer are equipped with
individual line outputs.
These line outputs feed pre-fader audio from the
corresponding input. They feature a ¼" line output jack operating at a nominal
level of -10dBv. These six outputs are un-balanced and are wired as follows:
Tip = audio signal, Ring = unused, Sleeve = Ground. These outputs can be used
for IFB feeds, individual camera feeds and for wireless transmission hops.
Headphone Outputs
The PSC ProMix 6 is equipped with two headphone jacks. These two jacks are
wired in parallel. One is a standard ¼" stereo jack and the second connector is a
3.5mm Mini stereo jack. Either jack may be used to drive headphones with any
impedance from 25 ohms to 600 ohms.
Front Panel View
Channel Fader
The PSC ProMix 6 audio mixer has six fader pots located across the front panel.
Each one of these fader pots controls the audio level of its corresponding input.
Rotating the fader pot clockwise increases audio level. Rotating the fader pot
counter-clockwise decreases the audio level.
7
Advertisement
Table of Contents
