Summary of Contents for Ideocentric Lumino360
- Page 1 Lumino360 Camera Instruction Manual Standard Definition Pan/Tilt/Zoom Video Conference Camera...
-
Page 2: Table Of Contents
Table of Contents Features Before Using the Product Safety Instructions Views and Interfaces Remote Controller Operation Specification Presets Installation AMERA NSTALLATION AMERA CONNECTIONS ETTINGS SETTINGS SW2 S ETTINGS Trouble Shooting Copyright Information Exclusion of Liability Note... -
Page 3: Features
Pelco D/P, VISCA protocol Before Using the Product Before you install the Lumino360 camera, check that all the items below are included and that the packaging and the contents are not visibly damaged. Contact the retailer immediately if any parts are either missing or damaged. -
Page 4: Safety Instructions
Safety Instructions The following safety instructions must be followed carefully to use the camera and respective accessories in total safety. The camera and relative accessories are called equipment in this section. 1. Before installing the camera, please read this manual carefully. Please follow instructions of installation indicated in this manual during installation. - Page 5 wipe it off gently with a soft cloth moistened with a weak solution of water and a neutral kitchen detergent. Wring all liquid from the cloth before wiping the camera, then wipe off all remaining dirt with a soft, dry cloth. Use lens cleaning paper to clean the lens. Never use benzene, thinner, other volatile or corrosive liquids or pesticides as they may damage the products finish and function.
-
Page 6: Views And Interfaces
Views and Interfaces Figure 1 – Lumino360 Front View Figure 2 – Lumino360 Rear View and connection points 01 Zoom module 07 S-Video output 02 Sensor for remote controller 08 RS-232 interface 03 Power light indicator 09 SW2 Baud rate, protocol and... -
Page 7: Remote Controller
Remote Controller Figure 3 - Remote Controller Button Description Turn off the operation of relative camera (starts from address 3) Example, 3+F2 Go to the initializing camera Home position 5 / 18... - Page 8 Turn on the operation of relative camera. (starts from address 3) Example: 3 + F1 Means: All the following operations are for Camera 3. Open to open IRIS and Close to Iris control close IRIS Control camera up, down, left Direction control and right.
-
Page 9: Operation
Operation Power On When camera is powered on, the power light indicator will flash, and the camera will pan / tilt automatically as a self-test. Pan/Tilt Control Press the arrow buttons to control the direction of the camera. The control light indicator will flicker once the camera receives the control command from controller. - Page 10 IRIS Control Press Iris Open button to control image brightness. Open (IRIS) - the camera Iris will become larger and the video will become brighter. Close (IRIS) - the camera Iris will become smaller and the video will become darker. Preset Control With the remote controller, you can Set, Clear and recall presets.
-
Page 11: Specification
Specification Mounting Type Ceiling-Mount or Desktop Installation Camera Specifications Signal Format PAL/NTSC Image Sensor 1/4″ SONY CCD Sony new E series Modules Sony FCB-EX48C(P) FCB-EX48E(P) Horizontal 480TVL 550TVL Resolution Effective Pixels PAL: 440,000 pixel / NTSC: 380,000 pixel Zoom Optical 18X/Digital 12X Lens f=4.1--73.8mm, F=1.4--F3.0 Illumination... - Page 12 Operation Video Output Interface Control Interface RS485/422, RS232 Baud 1200bps/2400bps/4800bps/9600bps/19200bps Rate(RS485/422) Comm. Protocol Pelco-D, Pelco-P Remote Control Work 0°C--+50°C Temperature Storage -20°C--+70°C Temperature Relative 0～95% without agglomeration Humidity Power Supply DC12V Power Less than 10W Consumption Dimension 156(L) × 137(W) × 140(H)mm Net Weight Body Color Black / Sliver Gray...
-
Page 13: Presets
Presets Presets Function 0-31 General presets Frame Scan (Scan Between Preset# 30 & #31) Auto Cruise 360º Scan 180º Scan Clear All Presets BLC On BLC Off Table 3 - Preset Descriptions 11 / 18... -
Page 14: Installation
Installation This section contains detailed instructions for installing the Lumino360 camera. These instructions assume that the installer has a good knowledge of installation techniques and is capable of adopting safe installation methods. Camera Installation There are two installation methods of the camera: Desktop installation and Ceiling installation. -
Page 15: Camera Connections
screws (M4) at the locations marked above to fasten the mounting base to the ceiling. Install the camera onto the mounting base, and tighten the camera with a screw (M3). Connect the power cable, video cable and control cable at the back of the camera. -
Page 16: Settings
Settings Before operating the camera, set the camera address, protocol, baud rate and image normal / mirror setting. The switches to configure these settings are located on back panel of the camera. The following figure (fig. 5) shows the switches on back panel, the ON direction is marked beside the switches. Figure 5 - Switches SW1 settings Camera... -
Page 17: Sw2 Settings
OFF OFF OFF OFF OFF OFF OFF OFF ON OFF OFF OFF OFF OFF OFF ON OFF OFF OFF OFF ON OFF OFF ON OFF OFF OFF OFF OFF ON OFF OFF OFF OFF OFF ON OFF ON OFF OFF OFF …... - Page 18 OFF OFF ON OFF Reserved OFF ON OFF Reserved OFF ON OFF Reserved Position 1200 OFF OFF OFF 2400 OFF OFF 4800 OFF ON Baud Rate 9600 (BPS) 19200 OFF OFF ON Reserved OFF ON Reserved Position Image not flip Image Flip Image flip Table 6 - SW2 camera Protocol, Baud rate and Image Flip Setting...
-
Page 19: Trouble Shooting
Trouble Shooting Problems Possible Causes Solutions Power supply failure Replace power supply No action when Wrong connection of Check & reconnect the powered on the power cables Mechanical failure Repair Abnormal self-test Camera inclined Reinstall the camera with motor noise Inadequate power Replace the power supply... -
Page 20: Copyright Information
Copyright Information Video or still images recorded using your Lumino360 cannot be used in ways that infringe copyright laws or without the consent of the owner, unless intended for personal use only. Exclusion of Liability If this camera is connected to a recording device (for example a VCR), VideoCentric...
Need help?
Do you have a question about the Lumino360 and is the answer not in the manual?
Questions and answers