Kenmore 790.9004 Series Use And Care Manual page 9

Setting Oven Controls
Should an oven fire occur,
close the oven door and turn off the oven.
If the fire continues, use a fire
extinguisher. DO NOT put water or flour
on the fire. Flour may be explosive.
The broiler pan and the insert (some
models) allows grease to drain and be
kept away from the high heat of the
broiler. DO NOT use the pan without the
insert. DO NOT cover the insert with foil;
the exposed grease could ignite.
To Broil:
1. Arrange the oven rack while oven is still cool. Position the rack and adjust the
Broil settings as suggested in the chart provided below:
Food Desired Doneness
Steak Medium
Medium-Well
Hamburger patties Well
Pork chops Well
Chicken Well
Fish Well
2. Press . " - - " will appear in the display.
3. Press or once to Broil with a normal setting (nor will appear in the
display).
4. To Broil with a high setting press
Broil with a low setting press the
5. The oven is properly set for Broil when the indicator light over the
flashing and glows steady. Broil may be canceled at anytime by pressing
at anytime.
Note: The Broil level setting may be changed anytime while broiling. To
change the level press
higher levels or for each desired lower level increment. Select the lo
broil setting to avoid excess browning or drying of foods that should be
broiled to the well-done stage.
6. Place the insert on the broil pan, then place the food on the insert (some
models). DO NOT use the broiler pan without the insert or cover the insert
with aluminum foil. The exposed grease could ignite.
7. Place the pan on the oven rack. Open the oven door to the broil stop
position when broiling (see illustration).
8. Broil on one side until food is browned; turn and cook on the 2nd side.
Note: Always pull the oven rack out to the stop position before turning or
removing food.
9. When broiling is finished, press
10. When removing broiler pan from the oven always use pot holders.
9
Setting
Hi
Normal
Hi
Normal
Lo
Lo
twice (hi will appear in the display). To
arrow twice (lo will appear in the display).
and press one time for each increment of
.
Rack
Position
2nd
2nd
3rd
3rd
3rd
3rd
pad stops