Ledco DS.GD8 User Manual

Computers not equipped with pass-through RF antennae should not be used on
DS.GD8 Docking Stations that are equipped with RF pass-through antennae.
Using this combination together can result in the chance that the on-board antenna circuit
in the computer could be damaged if exposed to sustained high vibration.
1. CONNECTING LAPTOP TO DS.GD8 SERIES DOCKING STATION
A.
Fit laptop into the
front mounting bracket.
If you try to connect laptop to the DS.GD8 while the mounting clamps
are engaged, you will need to press in barrel lock button to disengage
the clamps before proper connection can be made
2. POWERING DS.GD8 SERIES DOCKING STATION
WITH THE LAPTOP INSTALLED
A.
Toggle the on/off switch
to the ON position.
(Left side pushed in
indicates ON position)
1.877.875.5524
DS.GD8 Docking Station
Compatible with General Dynamics-Itronix GD8000 & GoBook XR-1 Laptops
B.
NOTE
B.
Additional mounting screws and keys are included in the attached Hardware Kit
Lower the back end
of laptop into place
and press down.
The green LED on the left side will indicate the DS.GD8 is
powering correctly, and the green LED on the right side
indicates that your laptop is connected to the DS.GD8
correctly and communicating with the docking station.
www.LEDCO-CHARGEGUARD.com/GD8Dock
User Guide
C.
Pull the front latching
lever forward to engage
the mounting clamps.
Check that laptop is
securely mounted by
pulling up on the laptop.
If it moves, repeat
steps B and C.
GD-0026-IS-A