Valor Multimedia iLink L2 User Manual

V A L O
V A L O
V A L O

INTRODUCTION

Valor Multimedia iLink L2 is an innovative digital multimedia player that acts as a bridge between the TV and
iPod™, MP3 Player, USA memory stick, USB hard disk drives and USB car readers. It is specifically designed to
access all the digital multimedia in the iPod, or USB Storage devices and allow you to view them comfortable on
you TV monitor. Valor's Multimedia iLink L2 lets you watch movies, view photos and play back any other
multimedia data stored in digital devices.
•
iLink shows all the iPod information on the TV screen and supports full control of iPod functions
through a remote control
•
iLink decodes and plays multi-format music, photo and video files stored in iPod or USB storage devices
•
iLink supports hot plug and play functions, letting the user connect and disconnect iPod or USB Storage
devices easily
•
iLink can be used as a battery re-charger for iPod even when its power is off (standby mode)
•
Even when the iLink's power is off, an iPod's audio/video data can be accessed through the iLink A/V
output
•
Easy firmware updates
•
iLink can be used as a home multimedia device as well as an automobile multimedia device. A
magnetic holder, for easy attachment and detachment is supplied.
•
Using the optional USB connection cable, iLink can work with MP3 players, USB memory sticks and
USB hard drives

INSTALLATION

1. Mounting the iLink L2

Choose a mounting location sufficient to bear iLink's dimension and weight for safe installation and use. Ensure
that the location where it will be instilled will not become subject to extreme temperatures or humidity.
After choosing a location and cleaning the mounting surface to which the double sided-tape of the magnet holder
is to be attached, peel the covering away from the double sided-tape and affix it to the mounting surface.
Affix the steel place onto the backside of iLink.
Put the iLink with steel plate on the magnet holder mounted on the surface.

2. Power Connection

There are two ways to connect power to the iLink. One is to connect it to the 12 Volt Accessory line of the car of
with the optional cigarette lighter cable
Connection with Power cable
Connect RED WIRE of Power cable supplied with the iLink to ACC+ and BLACK WIRE to GNG. Plug power
cable into the 12V DC power input terminal on the iLink. When connecting the power cable, make sure it is
routed and secured so it will not chafe on sharp edges or become caught in the car's dashboard panels.
Connecting with Cigarette lighter cable-Optional accessory
Plug Cigarette lighter cable (optional) into the cigarette lighter port of your car and connect the output terminal of
Cigarette lighter cable to 12V DC power input terminal.
Discountcarstereo.com
R M U L T I M E
R M U L T I M E
R M U L T I M E
D I A i L i n k L 2
D I A i
L i n k L 2
D I A i L i n k L 2