Summary of Contents for DNA AFD102
- Page 1 AFD102 10.2” FLIP DOWN WIDE SCREEN LCD WITH BUILT-IN DVD PLAYER Instruction Manual REV:10/10 www.dnaaudio.com.au www.dnaaudio.com.au...
-
Page 3: Table Of Contents
No picture A/V signal not present Check all cables. If Thank you for purchasing this DNA Designer Audio product. It is designed necessary, repair or to give you many years of enjoyment. DNA Designer Audio recommends Contrast and/or replace A/V source installation by a professional installer. -
Page 4: Safety
Safety On Screen Menu System 1. Press the “POWER” key on monitor or remote controller to turn on. Alteration or modifi cations carried out without appropriate authorization may 2. Press the “SELECT” key on monitor or remote unit, the ON SCREEN invalidate the users right to operate the equipment and void warranty. -
Page 5: Specifi Cations
On Screen Menu System Specifi cations Model: AFD102 The monitor incorporates an on-screen menu display systems which Operating Voltage: 12V DC permits you to setup the DVD for a wide variety of installations and Ground: 12V Negative applications. AV System: Screen Size: 10.2”... -
Page 6: Contents
Contents Wiring Diagram Note: The following accessories are included along with your fl ip down DVD player. 1. Please remove the right-side of the dome light cover to defi ne the door trigger. If it’s positive trigger (+12 Volt), please put the switcher to the left –... -
Page 7: Monitor Installation
Wiring Diagram Monitor Installation CAUTION: On a towel or soft cloth, gently place the monitor assembly “face down” on a stable work surface. Using the wires provided, complete the audio, Make sure the screws are NOT long enough to go through the roof! video and power connections in your vehicle as shown in the diagram If you have any doubts about this type of installation, please consult below. -
Page 8: Releasing The Monitor
Monitor Installation Remote Control Features Releasing and lowering the monitor FUNCTION ZOOM FUNCTION To release monitor press open button carefully lower screen to your Press this button to have the Available only in DVD mode. DVD feature function as below, best viewing angle. -
Page 9: Powering The Monitor
Remote Control Features Monitor Installation Powering the monitor EJECT EJECT To turn the monitor on, press and hold the POWER button for two Press this button to stop playing and PLAY/PAUSE/ ENTER seconds. When the power is ON, if an input signal is present, the eject the disc. -
Page 10: Controls & Features
Controls & Features Remote Control Features Monitor Controls & Features DVD EJECT 1) DVD POWER ON/OFF Press this button to stop playing This button turns the DVD system and eject the disc. on and off. 7) MONITOR OPEN SWITCH 2) AV MODE MONITOR POWER FM TRANSMITTER Press this button to select the...
Need help?
Do you have a question about the AFD102 and is the answer not in the manual?
Questions and answers