Schlage Link LE120 User Manual

Introduction
The Appliance Module (model LE120) works with the Schlage
LiNK system as both a lamp or small appliance controller and a signal
repeater to help extend the range of the Schlage Bridge.
Installation
1. Plug the appliance module into any available outlet.
• The appliance module can be used to control a lamp or small
appliance.
• The appliance module repeats the Z-Wave™ signal. In some homes,
the appliance module must be used to improve communication
between the bridge and the lock. During the online portion of the
setup, the system will determine if it is communicating properly or not.
You can move the appliance module during online setup if necessary.
• The appliance module should be installed into any indoor, three-
prong, 220-240 volt A/C outlet.
2. (Optional) Plug a lamp (incandescent or CFL) or small appliance
into the front of the Z-Wave™ appliance module.
Enrollment
1. Disconnect the bridge from power and Ethernet.
2. Install a 9-volt battery into the bridge (supplied).
3. Hold the bridge within 1.8 metres of the appliance module
throught all of the next steps.
4. Press and release the plus (+) button on the bridge.
5. Press the button on the appliance module.
6. Observe the lights on the bridge. The orange light will blink rapidly
while enrollment is taking place. Enrollment is complete when
the orange light becomes solid.
7. Uninstall battery from bridge.
8. Reconnect power and Ethernet to the bridge.
Appliance Module
Model LE120

User Guide

1
2
3
Press
Hold
within1.8m
Max. 600W
Incandescent
Press