Getting to Know Your Umniah Router Application Scenarios Scenario 1: You can connect your computer to Umniah Router to access the Internet. The specific connection steps depend on your computer's operating system. Follow the displayed instructions to connect Umniah Router to your...
Page 2
Scenario 2 (Optional): You can connect a telephone to Umniah Router's telephone port to make voice calls. Appearance 1. Power button 8. LAN indicators 2. Wi-Fi/WPS button 9. External antenna port 3. Dial-up button 10. Telephone port 4. USB indicator 11.
Page 3
Indicators Indicator Status Steady on: USB storage device connected. Off: USB storage device not connected. USB indicator Steady on: Wi-Fi turned on or data transfer in progress. Blinking: WPS connection being set up. Wi-Fi/WPS indicator Off: Wi-Fi turned off. ...
2. Insert the SIM/USIM card into the card slot. Ensure that the gold contact area faces down and that the beveled edge of the SIM/USIM card aligns with that of the card slot. 3. Slide the card cover back onto Umniah Router.
Page 5
Using the Table Stand (Optional) You can place Umniah Router on a flat surface such as a table or a desk, or hang it on a wall. You can also use the table stand on Umniah Router to place it upright.
Page 6
Installing an External Antenna (Optional) In areas with poor network coverage, connect an external antenna to Umniah Router's external antenna port. Screw the external antenna in fully, as shown in the following figure. Note: Skip this section if you do not need to connect an external antenna to ...
If you want to use Umniah Router to make voice calls, connect Umniah Router to a telephone, as shown in the following figure. Note: Skip this section if you do not plan to use Umniah Router's voice services. Radio signals can interfere with telephone call connection and quality. To ...
Connecting to a USB Flash Drive, Portable Hard Disk Drive, or USB Printer Connect a USB flash drive, portable hard disk drive, or USB printer to Umniah Router's USB port, as shown in the following figure. For details, see the help information on the web management page.
Powering Umniah Router On or Off After connecting to a power outlet, Umniah Router will power on automatically. To manually power Umniah Router on, press and hold until all indicators turn on. To power Umniah Router off, press and hold until all indicators turn ...
Page 10
If a security mechanism has been enabled for the wireless network connection, enter the correct network key. The SSID and the network key are printed on Umniah Router label. Method 2: (Optional) Set up a WPS connection. If the client to which your device connects supports WPS, a network key is generated automatically.
Umniah Router will automatically disconnect from the Internet. Using the Web Management Page You can configure and manage Umniah Router settings using the web management page. 1. Launch a web browser, and enter http://192.168.1.1 in the address bar.
Restoring Factory Defaults If you are uncertain of which settings you have configured or changed, you can restore the factory defaults that Umniah Router came with, and then reconfigure Umniah Router. To restore the factory defaults, Use a sharp-pointed object to press and hold the...