Airplane Disassembly; Wing Disassembly; Wing Assembly; Htu Disassembly - Urban Air UFM – 13 LAMBADA Operating And Maintenance Manual

OPERATING AND MAINTENANCE MANUAL FOR ULTRALIGHT AEROPLANE
4.9.

Airplane disassembly

4.9.1. Wing disassembly

3 persons are needed to accomplish this task
Wing disassembly procedure:
1. Unlock the rear pins – slightly pull and turn the pins /90°
2. Unlock the main pin – turn it 180° and take out
3. Pull the right wing from the fuselage (disconnect the fuel tank hose and fuel quantity load
sensor). The left wing must be held at this time!
4. Pull the left wing from fuselage (disconnect the fuel tank hose and fuel quantity load
sensor).
The position light wires must be disconnected if installed, also

4.9.2. Wing assembly

Follow the wing disassembly procedure in reverse order
Carefully shift the control system bells into the automatic grips of ailerons and flaps control
system

4.9.3. HTU disassembly

1. Rematch the safety pin and unscrew the M8 screw

2. Pull the HTU rearward and lifted ( disconnected the position light /anti collision bacon if
installed after HTU disassembly)
3. Remove the HTU

4.9.4. HTU assembly

Follow the HTU assembly procedure in reverse order
Carefully shift the elevator control bell into the groove at the automatic guiding of the HTU
control
Document No:
Date of issue: 30.01.2008
UFM-13 Lambada
No special qualification needed for assembling/disassembling.
CAUTION
CAUTION
Note
4-10