Page 1
Set Up Guide & User Manual Williams Sound Hearing Helper ™ Tour Guide System, Model TGS 200 Wireless, Portable FM Listening System ® Transmitter Model T1-216 Williams Sound Receiver Model R1-216 Helping People Hear...
FM T TGS 200 UIDE YSTEM ODEL & U NSTALLATION UIDE ANUAL Contents Page YSTEM VERVIEW YSTEM OMPONENTS T1-216 T RANSMITTER ICROPHONES R1-216 R ECEIVER & E EADPHONES ARPHONES PERATING NSTRUCTIONS T1-216 T RANSMITTER R1-216 R ECEIVER INTS FOR SING THE...
100 meters away. To avoid difficulties, please read through these instructions as you begin to use the system. Then save them for questions that arise as you continue to use your Williams Sound FM Tour Guide System.
The headphone plugs into the “EAR” jack on top of the Receiver. The receiver is turned on by rotating the volume control wheel. The R1-216 Receiver operates on two AA non-rechargeable alkaline batteries (BAT 001), or two AA rechargeable Ni-Cad batteries (BAT 026). ® Williams Sound Helping People Hear...
The foam pads can be removed for cleaning or replacement. Replacement pads are part number EAR 015-10. . 2: E ARPHONE EADPHONE PTIONS HED 008 EAR 022 EAR 013 EAR 014 ® Williams Sound Helping People Hear...
On/Off Switch Jack ON Indicator Williams Sound FM 4. Turn the power switch on top of the transmitter to “On.” 5. Position the Headset Microphone boom as close to the wearer's mouth as possible without actually touching. Lapel Clip microphones should be attached to a collar or lapel, as close to the wearer's mouth as possible.
For maximum range, the cord should hang as straight as possible. The transmitter can be placed in a pants pocket, or clipped onto a belt or waistband. Make sure the transmitter is turned OFF when not in use. ® Williams Sound Helping People Hear...
The physical separation of groups takes advantage of the FM capture effect which causes receivers to lock onto the closest transmitter. 4: T IGURE UIDE ROUP EPARATION Tour Group 1 Tour Group 2 30 Meters Channel A Channel A ® Williams Sound Helping People Hear...
The battery installed in the receiver may be recharged in the receiver only if it is a Nickel Cadmium battery, and only if a Williams Sound CHG 1600 Multi-Charger is used. Damage from improper charging is not covered by the Williams Sound five year warranty.
CHG 1600 Multiple Charger for more than 15 hours without harm. Williams Sound rechargeable AA batteries can be charged on a daily or less frequent basis. CHG 1600 C IGURE SING HARGER Charging Indicators Charging Contact Holes Charging Pins ® Williams Sound Helping People Hear...
6. If you are still hearing interference on the receivers, turn the transmitter off and listen with a receiver. If you hear the interference with the transmitter off, you need to change to a clear channel. Call your Williams Sound at 1-800-328-6190 for details. ®...
If you experience difficulty with your system, call for Customer Assistance: 1-800-328-6190. If it is necessary to return the system for service, a Williams Sound representative will give you a Return Authorization Number (RA) and shipping instructions. Pack the system carefully and send it to: Williams Sound Corp.
35 mW, max. at 16 Ω Audio Output: Output Connector: 3.5 mm mono phone jack Squelch: Set to turn off audio under weak or no signal condition Controls: Volume: thumbwheel/on/off/volume Indicators: On/off Note: Specifications are electrical performance ® Williams Sound Helping People Hear...
Need help?
Do you have a question about the TGS 200 and is the answer not in the manual?
Questions and answers